{*ice killahfcXATYZFatgfdcxwECUTGAQF H
no
Removing the roof panel requires that you locate and back-out two screws from the rear of the panel, and the two at the front..., there was a tool supplied in the center console for this purpose.
corvette 1994
Remove the 4 bolts at each corner of the top with the supplied tool that should be in your console. If the tool is missing, seek a replacement.
Remove the floor sill covering, it has 5 or 6 screws, then you can access the speakers.......
To remove the center console on a 1994 Chrysler LeBaron, start by disconnecting the negative battery terminal to ensure safety. Next, remove any screws or bolts securing the console, typically located in the front and rear. Carefully lift the console up and out, being mindful of any electrical connections for the gear shifter or accessory outlets. Once disconnected, you can fully remove the center console from the vehicle.
To change the center console on a 1978 Corvette, first, remove the seats for easier access. Next, detach the screws and clips securing the console to the dashboard and the floor. Carefully lift the console out, disconnecting any electrical connectors, and then install the new console by reversing the steps. Make sure everything is securely fastened and reconnect any wiring before re-installing the seats.
you get a hack saw and cut it off or get an alluminion blade to saw it off
switch should be on the bottom of the steering column ,probably have to drop the two bolts on console to get to it
1980 corvette , how to remove speedometer
The flasher unit on a 2000 Corvette is built into the emergency flasher unit in the console.
REMOVE THE CENTER CONSOLE TRIM FROM AROUND THE GEAR SHIFT. ONCE THAT IS OUT OF THE WAY THERE ARE TWO BOLTS THAT HOLD THE IGNITION SWITCH IN THE DASH. REMOVE THE BOLTS AND THE ELECTRICAL CONNECTOR AND YOU SHOULD HAVE IT IN YOUR HAND.