answersLogoWhite

0

The tire will squeek because the tire rubs againist the rubber coated mounting bar. Place a thick/heavy sponge between the tire and mounting bar.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is the spare tire on a 96 Chevy Blazer?

the spare tire should be on the under carriage under the trunk of the Blazer


How do you remove spare tire from a 2000 Chevy Blazer After inserting key?

I have a Chevy Blazer 2000 4 Wheel Drive ZR2 The Spare Is On The Back With a Lock How do I remove the Spare Tire Thank You


Where is the spare tire in 1996 chevy blazer?

It is under the rear of the vehicle.


Where do you get the kit to hook your spare tire for your 2004 Chevy blazer?

save money junkyard.


What is the gate that holds the spare tire on a Chevy S10 Blazer called?

I'm semi-sure it's called a spare tire carrier.


Where is paint code located on 1999 Chevy blazer?

Check the service tag inside the spare tire cover, on the firewall (a bit hard to see with everything together), and inside the driver side door jamb, either on the door, or on the jamb


Where is the fuse box in a Chevy Blazer 96?

The fuse box is located in the driver door joint. There is a small panel held on by a small hand screw. Inside you will find the panel diagram and any spare fuses.


Where is the evap purge vent solenoid located on a 2003 Chevy Blazer?

It is near the gas tank. You have to remove the spare tire to access it.


Where is battery located in 2005 Chevy Cobalt?

Inside the trunk near the spare tire.


Spare tire and jack located on a 04 Chevy blazer?

If I remember correctly, it is located in the back hatch on the drivers side, behind a cover in the trim (Jack) and the spare tire should be under the back end behind the bumper.


How do you fabricate a spare tire hoist for 96' Chevy s10 blazer?

You can purchase a used one from your local salvage yard. This would be easier than building one.


How do you remove the spare tire on Chevy Blazer?

The spare tire is located under the rear of the truck. Insert the flat end of the tire iron into a hole located on the right side of the rear bumper and crank until the tired drops down to the ground.