with ignition switch problems i find its easyer to replace the hole colum with another one from a junk yard, there is a lot of special tools to take a colum apart or just fork out the cash to have a lock smith to change it
Ignition switch.
Begin by removing the retaining ring at the top of your 1990 Pontiac Bonneville ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.
How do you replace the ignition swith opn a 1992 Pontiac Bonneville se
No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.
I have to jump start my Pontiac Bonneville 1988 everyday I drive it why is that.
To remove the ignition switch from a 1970 Pontiac GTO, first disconnect the battery to ensure safety. Then, remove the steering column cover by taking out the screws or bolts securing it. Locate the ignition switch, disconnect the wiring harness, and unscrew the switch from its mounting position. Finally, pull the switch out carefully from the steering column.
pull it really hard
The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.
On the 2000 Pontiac Montana, the ignition switch is located on the steering column, behind the steering wheel. To access it, you typically need to remove the lower steering column cover. This switch is connected to the ignition lock cylinder, allowing you to start the vehicle when the key is turned.
http://www.automotivehelper.com/topic1054152.htm or Goole "ignition switch replacement 2001 regal"
To remove the ignition switch from a 1997 Pontiac Trans Sport, first disconnect the negative battery cable to ensure safety. Next, remove the steering column covers by unscrewing the screws holding them in place. Then, locate and disconnect the wiring harness from the ignition switch, and unscrew the ignition switch from its mounting bracket. Finally, carefully pull the switch out to complete the removal process.
ignition switch or key and tumbler.