11
11 grease fittings
On a 2010 Chevy Avalanche, grease fittings, also known as zerk fittings, are typically found on various suspension components, such as the ball joints, tie rod ends, and control arms. However, many modern vehicles, including the Avalanche, may have sealed units that do not require regular greasing. It's advisable to consult the owner's manual or a service guide for specific locations and maintenance recommendations for your vehicle.
2 Grease Fittings. One on each Tie Rod End.
two
There are no grease fittings on this vehicle. Many aftermarket parts do have them, though.
A 2013 Chevrolet Avalanche typically has several grease fittings, primarily for the chassis and suspension components. The exact number can vary depending on the specific configuration and whether any aftermarket modifications have been made. Generally, you can expect around 6 to 12 grease fittings throughout the vehicle. Always refer to the owner's manual or service guide for precise information on maintenance points.
There is 11 grease fittings in the front end parts. You have 1 fitting in the front driveshaft, could have 1 in each u-joint. There may be fittings in the rear drive shaft too. There is 11 in the front Suspension for sure, and that is not counting the driveshafts.
41
There are approximately 20 grease fittings in the regular car. However, it will vary depending on the make and model of the vehicle.
none
Geo Prizms have no grease fittings. All parts are sealed units and simply must be replaced when they wear out.
Zero