Is it a front and rear lowering kit? what type of kit is it? shackles and hangers? drop blocks? smaller coil springs or drop spindles? let me know.
About 2 and 1/2 hours.
About 30 min.
Mitchell labor estimating guide for a 99-2000 silverado 4wd 4.9 hrs and with skid plate add .2 engine and trans combos would make a little dif
The duration of Silverado - film - is 2.22 hours.
have you tried turning off the radio and then press the set button then press the scan (up, dn) for hours then seek (up,dn) for minutes then press set again
A little under two hours
In a garage, with a lift and experience, under 3 hours. In your driveway, on the ground with no experience, all weekend.
Really depends on whether or not you know what you're doing. If you do, a couple hours, you can have the old one out, the new one stabbed in, and be done with it. If not, it could be an all-day thing.
2.65 hours + 2.15 hours = 4.8 hours or 4 hours 48 minutes.
To do this correctly it takes around ten hours more or less depending on level of experience
In a shop with a lift, correct tools, and replacement parts at hand, aprox one hour.
If its like my '90, power off the radio so that the time displays. Then, hit Set. Then the Seek/Scan buttons will change the hours and minutes. When you are finished, hit Set again to get out of Clock Setting mode.