Depends on your experience with cars and the models and if all parts are available to you but if they are about one no more than two hours, if a rookie is in process than about two hours as well, recommend another head in the project though.
how to i change a clutch in a 1993 ford ranger
On the 1996 Ranger the manual shows to lift the clutch pedal every 5,000 miles to adjust the hydraulic clutch , I don't know if yours is the same
yes.
For a 1993 Ford Ranger : ( DOT 3 brake fluid , meeting Ford specification ESA-M6C25-A ) is used as a fluid for the hydraulic clutch
there is not adjustment for the clutch, you need to replace it if is bad.
Probably a worn out clutch disc.
The clutch replacement labor time is 6.7 hours. Expect another hour if the flywheel needs to be turned or replaced. It is quite an extensive job because the transmission has to be removed.
The cost to replace the clutch on a 1993 Toyota Celica will vary depending on labor and part costs. The clutch for the vehicle costs approximately $67.63 in some stores.
I know on the 1996 Ranger the manual shows to lift the clutch pedal every 5,000 miles to adjust the hydraulic clutch . I don't know if yours is the same
The estimated cost for parts and labor to replace the clutch on a 1993 Toyota Camry is between $1,260 and $1,687. This can be higher or lower depending on where a person lives.
Verify that the clutch is working. If there are noises, there is a problem. Disconnect the negative charge. Lift the vehicle up and support it. Support the engine with a hoist. Disconnect clutch linkage. Remove the clutch and replace it.
you will have to remove the transmission. once you have the tranny off you can remove and replace the clutch...if you buy a new clutch specific directions will come with it...too long to write here.