answersLogoWhite

0


Best Answer

There are two oxygen sensors on a 1989 Crown Victoria. One is located on each of the exhaust pipes coming off the exhaust manifold.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How many o2 sensor does a 89 Crown Victoria have?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How many lugs on 89 Crown Victoria?

On a 1989 Ford Crown Victoria : ( there are 5 lugs per wheel , total of 20 )


How many gallons does it take to fill up a 89 ford crown victoria?

On a 1989 Ford Crown Victoria : The gas tank size is ( 20 U.S. gallons ) according to my Chilton's repair manual


Will a 1989 crown Victoria fender fit on a 89 grand marquis?

No, the Crown Vic and Grand Marq used different styles of fenders


How does your fuel gauge work on your 89 crown vic ltd?

signal from the sensor inside the tank to the gauge


Cost for pcm replacement on 2000 crown Victoria?

On the used side, $40ish at a junk yard. Ebay is running about $89-$130.


How much oil does a 89 crown Victoria hold?

Drain oil and replace filter. Add 5 quarts and check the level.


How do you install a Ford Crown Victoria window?

If it is a older Crown Victoria,( had to replace a window in 89 grand marq.) you have to take off the door panel to get to the window motor and i believe also there are some springs too, and put it on track. Isn't much of a answer you was looking for but it's a start...


How will you know if the neutral switch is bad in a 89 Ford Crown Victoria?

put it in drive gear and try and start it if it does start while in gear its bad if it doesnt its good.


What is the problem of 89 crown Victoria's having starting problems?

Starting poblems? Like, no fuel, no ign. (fire) does the engine turn over? Need more info.


How many gallons of gas does 89 crown vic hold?

exactly 20 gallons


How do you install a durabrand stereo in a 89 ford crown Victoria?

IT DEPENDS SOMETIMES YOU HAVE TO WACK A LARGER HOLE IN THE DASH WITH A SAWS ALL .. BE CAREFUL YOU COULD BE GETTING YOURSELF INTO A JOB YOUR NOT PREPARED TO DO


What is wrong if you hear a loud grinding noise when you try to start an 89 Crown Victoria?

It sounds like you need either a flywheel or the bendix on the starter is worn out. Easy fix if it is starter.