0
What else can I help you with?
How do you clean the evap canister on a 1996 dodge ram 1500?
It can not be cleaned. It must be replaced.
How do you Reset oxygen sensor dodge ram 1500?
The oxygen sensor can not be reset and must be replaced if defective.
What causes a leaf springs to crack on 2005 dodge ram 1500?
They must be crap! Our company has two dodge 1500's, and one 2500. We have had four broken leaf springs so far. we never carry heavy loads in two of these trucks. Dodge should recall them. Do i hear class action?
Will a 1997 Dodge Ram 1500 5.2 fit a 1999 Dodge Ram?
the engine will fit but the swap isn't emmisions legal.any swapped engine must be from the same year or newer vehicle.
Is there a shortcut in replace a heater core in a 1996 dodge ram 1500?
No, dash and HVAC housing must be removed.No, dash and HVAC housing must be removed.
Where is the fuel pump on a 1996 dodge ram 1500?
It is located in the gas tank. Gas tank must be removed and the pump comes the top
Why in my 1999 dodge ram 1500 4 wheel drive light always out?
a wire from the light to the main box must be out. Or the fuse is busted
How do you reset a speed sensor on a 2003 dodge ram 1500 quad cab 4X4?
There is no speed sensor reset. IT must be repalced if failed.
Fuel gauges does not work 1996 dodge ram 1500?
If the fuel gauges on a 1996 Dodge Ram 1500 stop working the fault may be in the sending unit. ?æThis unit is located in the gas tank and one must replace the sending unit/fuel pump assembly.
How do you remove the oil pan on a dodge ram 1500 with a 5.9L engine?
The oil pan on a Dodge Ram 1500 with a 5.9L engine is removed by draining the oil, removing the retaining bolts, and lowering the pan from the vehicle. The gasket material will create a strong seal which must be broken before removal.
Do you have to take off the alternator to change the thermostat on a 1998 dodge ram 1500?
most V6/V8 models the alltenator must be removed or repositioned to gain access to the thermostat housing
Where is the ac orifice tube on a 99 DODGE ram 1500?
It is made into the high pressure line about midway where it runs along the passenger side fender. If replacing, you must replace the whole line.
