2000LBS
turn on the running lights and pull out on the multi switch.
To remove the subwoofer from your 2004 Jeep Rubicon, start by disconnecting the vehicle's battery to avoid any electrical issues. Then, carefully remove the rear panel or cargo area cover to access the subwoofer. Disconnect the wiring harness and unscrew any mounting screws holding the subwoofer in place. Finally, gently pull the subwoofer out of its enclosure.
Check inside the glove compartment (pull the whole compartment out).
You need to remove the glovebox. Its located in the dash under the glovebox. It is held in place by 2 screws and a harness. Remove the harness and screws and pull out and down from underneath the dash. Put the new one in in the opposite order.
in a 2004 rubicon behind the glove box on the fuse panel are 2 fuses outlined in black that say airbag i can only guess to pull the fuse My 2000 has a switch in front of the shifter for turning off the passenger airbag.
5000 lbs
I believe it is behind the rear passenger tire. You have to pull out the plastic in the wheel well to get to it.
My Jeep liberty fog lamp switch will not pull out unless the control for the headlights is turned on first. Could this be the reason?
Unbolt it at the shackles, and pull it out from the output shaft.
It is if you use cables to pull it up to the ceiling of the garage. Otherwise it takes at least 2 people. You don't want to do it every time it rains, but definitely worth taking off.
You have to remove the whole headlamp assembly. Remove the 1 bolt 6mm? and pull outwards.
Yes