If the system was completely empty, the block, the heater core, the radiator and all hoses, the system would take 12 to 13 qts depending if it has A/C or not.
The engine block coolant drain plug on 4.3 liter Chevy Blazer is located on the bottom of the engine, near the oil filter. It allows coolant to be completely drained from the block during maintenance.
Well , in a 1999 CHEVROLET BLAZER , the 4.3 liter V6 engine is rated at : ( 190 horsepower from the factory )
10 degrees
No it does not.
The 1989 Chevrolet Blazer 4.3 liter engine starter can be found on the right hand side of the engine. The starter will be near the back of the engine.
A Chevrolet Blazer with a 4.3 liter vortec engine will take approximately 6 quarts of oil. The recommended type of oil is 5 W 30.
It is on the driver's side head by the back spark plug.
Passenger side, side of cylinder head next to sparkplug, single wire sensor, needs offset 13/16 wrench to remove.
The coolant temperature sensor, on a 2005 Chevrolet trailblazer 4.2 liter engine, is located just above the thermostat housing. The thermostat housing is located in the front of the engine.
The firing order for the 2001 Chevrolet Blazer is 1, 6, 5, 4, 3, 2. This is for the 4.3 Liter engine.
A 2000 Chevrolet Silverado with a 5.3 liter engine takes 13.4 quarts of coolant. It is suggest that the coolant be mixed 50/50 with water.
If the system is dry, then it will hold 17.5 qts.