answersLogoWhite

0

It depends on qualifications and experience as well as certifications. My husband has 9 years experience and makes $60,000/year at a collision shop...no custom work.

User Avatar

Wiki User

13y ago

What else can I help you with?

Trending Questions
Does dodge rear ends interchange with older gm trucks? What is the Cubic inch size of 6.6 liter engine? Where are the freeze plugs located on a 1998 dodge spirit le 2.5 automatic By the firewall area. I know one of mine is leaking.? Can you hook up a car seat to a 1999 ford expedition xlt? Where is the mass air flow sensor located on a 2000 ford f-150 5.4? How many gallons does the fuel tank hold on a 1986? Where is the flasher for the blinkers on a 1994 Oldsmobile Achieva S? Arp 4 bolt main torque specs sbc? How do you replace the rear main seal on a Ford F-150? How do you remove armrest on 2001 ford excursion? Do dually trucks come in a 6 ft bed? What do you do if your transmission dip stick is stuck and no matter how hard you pull it won't come out? What would cause a 1993 Chevy cavalier to overheat and not start? How do you remove front hub bearings? What is the lug pattern for a 1979 Chevrolet Impala? How do you tighten the tilt on a 1983 Chevy Blazer K5 steering column after the steering wheel and metal plate under it have been pulled? How do you take apart the dash board of a 1997 Buick Park Avenue Ultra? How do you replace the water pump on a 1997 GMC Jimmy vortec v6 and removing the clutch fan shaft? What is the towing capacity for a 2002 jeep wrangler 6 cylinder? What could be causing the power to shut off to the fuel pump after it is run for a while on a 2001 Chevy Tracker. With a new fuel pump. Had the ECM checked and changed the relay. Happens after its hot?