1500lbs
365
Stock 350 horsepower. With all the mods you can achieve 1,250 horsepower. (But you run the risk of blowing heads.)
According to the 2009 Mercury Mariner Owner Guide : With engine oil filter change : The 2.5 liter four cylinder engine takes ( 5.3 U.S. quarts ) The 3.0 liter V6 engine ( 6.0 ) * 5W-20
According to the 2009 Mercury Mariner Owner Guide : With engine oil filter change : The 2.5 liter four cylinder engine takes ( 5.3 U.S. quarts ) The 3.0 liter V6 engine takes ( 6.0 ) * 5W-20
Yes, the 2009 Mercury Mariner with a 3.0-liter V6 engine does have spark plugs. This engine is equipped with a conventional ignition system that uses spark plugs to ignite the air-fuel mixture in the cylinders. Regular maintenance of the spark plugs is essential for optimal engine performance.
The hidden factory entry code for a 2009 Mercury Mariner is typically found on a sticker located on the driver’s side door jamb or within the glove compartment. It may also be listed in the owner's manual. If you can't locate it, you may need to contact a dealership or a locksmith who specializes in automotive locks for assistance.
The OBD-II scanner connector on a 2009 Mercury Mariner is located under the dashboard, near the driver's side. Specifically, you can find it beneath the steering column, typically within a few inches of the driver's seat. It may be necessary to remove a panel or look behind the steering wheel cover to access it.
2010 and up 60 HP, 2006-2009 52 HP
The keyless entry code for a 2009 Mercury Mariner is typically found on a label located in the owner's manual or on a card that comes with the vehicle. If you cannot find it there, the code may also be on a sticker inside the driver's door jamb or on the side of the driver's seat. If the code is not accessible, you may need to contact a Ford dealership for assistance in retrieving it using your vehicle identification number (VIN).
On a 2009 Mercury Mariner, the keyless door code is typically found on a label inside the owner's manual or on a card that came with the vehicle. If the code is not available there, you can also check inside the driver's side door frame or under the dashboard near the fuse box, where manufacturers sometimes place the code. If you're unable to locate it, you may need to contact a dealership for assistance.
It will be necessary to remove the front license plate and bracket. Remove license plate from bracket. Using a 3/16" drill bit, drill out the two pop rivets that hold the bracket to the bumper. This is from a a bull bar installation guide for a 2008 Ford Escape/2008 Mercury Mariner.