0
Not all that expensive. Typically between 50 and 75 bucks. The labor is what kills you though. Most places charge 100-200 to put it in on top of the part cost that they mark up on you. If you buy it from Orielly or somewhere else and do it yourself you should stay under 100. Starters are very easy to put in too. I suggest you do that.
What else can I help you with?
Does a 1993 2.3 Ford Ranger have a non-interference engine?
Yes , the 2.3 liter 4 cylinder in a 1993 Ford Ranger is a non-interference engine
How much does a 1993 Ford Ranger 4-cylinder gas tank hold in gallons?
I have a '93 Ford Explorer and it hold 19 gallons From the Chilton Ford Ranger guide: "1993 Ranger with standard wheelbase: 16.3 1993 Ranger with long wheelbase: 19.6"
Why wont the new starter you replaced on your 93 ford ranger 4 cylinder disengage after starting engine?
Check and or replace your starter solenoid.
What size motor is in a 93 Ford Ranger xlt four cylinder two wheel drive five speed?
The 4 cylinder in a 1993 Ford Ranger is 2.3 liter ( 140 cubic inches )
What does the starter look like on a 1997 ford ranger?
a black cylinder with a big red wire and it on the drivers side
Can you use a transmission from a 1993 Ford Ranger to a 2000 ranger?
can you use a transmission from a 1993 ford ranger in a 2000 ford ranger?
Where is the starter solenoid on a Ford Ranger 1993?
On the drivers side on the bottom of the engine, it has a red wire going into it.
What are the cylinder numbers on a Ford Ranger?
where is the number 3 cylinder located on a 2.5 ford ranger engine
How do you change a 1993 Ford Ranger clutch?
how to i change a clutch in a 1993 ford ranger
How do you change a starter on a 1993 Ford Ranger?
Disconnect the - battery cable Raise and support vehicle Disconnect the wiring at the top of starter Remove starter mounting bolts Twist starter to remove
How do you fix a slave cylinder in a 1993 ford ranger?
you just need to hone it out and replace parts with rebuild kit.
Where is the clutch slave cylinder on a 1993 ford ranger 4x4?
I believe that is inside the manual transmission bell housing
