exhaust removal, driveshaft removal, shifter boot and shifter removal,transmission removal, removal of pressure plate and clutch disc, suggest replacing pilot bearing and replacing slave cylinder, removal and turning of flywheel, suggest replacing throw-out bearing. a full clutch kit will come with new pilot bearing, pressure plate and clutch disc, and throw-out bearing. generally a two man job
on tims HEAD
yes, some 1995 Chevy s-10 pick-ups did come with a manuel transmission. thus it uses a clutch (clutch plate, disc, throw out brg. and a pilot brg.)
Is this a trick question??? If it's an automatic it won't have a clutch pedal lol!
bad clutch, bad pressure plate, throw out bearing, air in the hydraulic lines...etc
fill the clutch resivoir pump the clutch pedal open the bleeder screw and tighten it back up and repeat until the air is out and just fluid comes out
You are low on refrigerant, google R134a...
I need to replace release bearing in a 1995 Chevy s10 truck and need to know how to disconnect the hydraulic clutch line for the transmission.
same way as on most models,except it has a fifth bolt on the top of the bell housing
You have to remove the transmission to get to the clutch slave cylinder on that truck. You can pull the engine if you want and get to it. YOUR CHOICE.
Does my 1995 Toyota Paseo have a clutch cable
There is one for the AC compressor clutch and one for the blower motor high speed.
how much cost to change a clutch for a geo prizm 1995