0
The LT1 connecting rods, commonly found in General Motors' LT1 engines, can typically handle around 500 to 600 horsepower in a stock configuration. However, their power capacity can vary based on factors such as engine tuning, RPM limits, and specific application conditions. For higher power levels, aftermarket rods designed for increased strength and performance are often recommended. Always consult with a performance expert for specific builds and power goals.
What else can I help you with?
If you stroke 350 Chevy will connecting rods hit camshaft?
Typical 383 type stroker kit....absolutely not...not the cam anyway. On some blocks there are places that the rods may hit the block itself...at or near the oil pan rail. This is an easy fix. Install the crank and rods. Turn it over by hand and check clearances. Anything hitting or extremely close take a dremmel or small grinder to the area of the block. It shouldn't take much to do the trick.
What is the function of the control rods in a power plant?
The control rod would have a tendency to absorb neutron which is the key for nuclear fission. So by inserting control rods such as Cadmium or Boron rods the reaction rate can be reduced. If we take off the rods the rate of reaction would increase.
How could you design a powerstation to take advantage of nuclear fission?
Within this power station, what are the control rods: What are they made from? What do they do? How do they do it?
How do you take apart a sectional sofa held together by metal rods that slide from one piece into another?
Start by removing any cushions and accessories from the sofa. Locate the metal rods connecting the sections and use a hammer or rubber mallet to gently tap them out of place. Once the rods are removed, carefully lift and separate the sections of the sofa. Be cautious while dissembling to avoid damaging the sofa or injuring yourself.
What are ligtning rods?
Invented by Ben Franklin lighting rods are just what they sound like they are rods on a roof to take lighting instead of it hitting a house and burning it down.
How much power does it take to power Disneyland?
That information is unknown to the public.
How many rods are there in 99 ft?
1 rod = 16.5 ft, therefore u take 99X16.5=1633.5 rods
Best type of power plant?
Nuclear power is the best by far because you take pellets that have a uranium orb in the middle then stabilizer rods come in stabilize them and then water is poured on them to generate steam that rises through a turbine and spins the turbine generating power
How much hydroelectric power is in Michigan?
As much as yor mom can take
Do you have too remove the rods and rocker arms on a Chevy 350 before you take off the heads?
PUSH rods and rocker arms... yes.
How do you stop your nomes populating?
take their fishing rods then they cannot mate
Should curtain rods be professionally installed?
No, curtain rods do not have to be professionally installed. Some curtain rods are tension type rods and don't require hardware installation. For the curtain rods requiring installation, most come with instructions. Simply take your time and follow the instructions and you should be able to install your curtain rod without a professional!
