answersLogoWhite

0

Right rear wheel cylinder (assuming you have a drum brake in the back) is a couple bolts and an oil line going in. You would need to remove the drum brake parts to remove it but a new cylinder would probably run around 20 bucks in an auto part store.

If it is a disc with caliper and it is leaking from the caliper piston itself, your looking at a new caliper which may run around 40 bucks. You may just have a line leak and in the rear it should be pretty easy to remove and replace with a new section.

Bleeding the brakes should be done for both rear brakes at the same time to be certain. You need to open the bleeders to do this. Be careful, use penetrating oil and plenty of time.. maybe a lil heat as well.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you know when you need a new master brake cylinder?

A brake master cylinder? If you are losing brakes or brake fluid.


Do 1998 Saturn's have brakes shoes or disc rear brakes?

1998 GM Saturn (all models) have rear brake shoes


What should you do if your car brakes are not working and the brake pipe is leaking?

Don't drive and take it straight to a garage 'cause it will empty your brake cylinder.


Should both chambers be full of brake fluid in a 1986 ford f 150 master brake cylinder?

yes , 1 chamber is for the front brakes and the other chamber is for the back brakes


Do you bleed brakes on a 1986 Mazda B2000?

Yes, you should bleed the brakes on a 1986 Mazda B2000 if you notice a spongy brake pedal, after replacing brake components, or if air has entered the brake lines. To bleed the brakes, start with the wheel farthest from the master cylinder and work your way to the closest. Use a helper to pump the brake pedal while you open and close the bleeder valve on each brake caliper or wheel cylinder. Make sure to keep the master cylinder topped off with brake fluid throughout the process.


On a 93 ford tempo master brake cylinder are the front brakes controlled by the lines on the bottem of the master brake cylinder or the sides?

. If you have the 4-port master cylinder, the bottom ports go to the rear brakes & the upper side ports go to the front brakes.


What is meant by replace brake cylinder repair?

Brake cylinder repair is that wheel cylinder that holds the oil to keep your brakes running smooth on your back brakes. If you don't repair those you will mess up your rotors and your rims.


What is the function of the wheel cylinder?

A piston on each end of the wheel cylinder pushes outward when the brakes are applied. This pushes the brake shoes against the brake drum and stops the vehicle. The pistons are forced out by the pressure of the brake fluid inside the wheel cylinder when you apply the brakes.


What is the function of a wheel cylinder?

A piston on each end of the wheel cylinder pushes outward when the brakes are applied. This pushes the brake shoes against the brake drum and stops the vehicle. The pistons are forced out by the pressure of the brake fluid inside the wheel cylinder when you apply the brakes.


What function does the cylinder perform in the braking system?

A piston on each end of the wheel cylinder pushes outward when the brakes are applied. This pushes the brake shoes against the brake drum and stops the vehicle. The pistons are forced out by the pressure of the brake fluid inside the wheel cylinder when you apply the brakes.


What function does the wheel cylinder perform in the braking system?

A piston on each end of the wheel cylinder pushes outward when the brakes are applied. This pushes the brake shoes against the brake drum and stops the vehicle. The pistons are forced out by the pressure of the brake fluid inside the wheel cylinder when you apply the brakes.


Should the brake pedal go to the floor on a car equipped with anti lock brakes?

No, Check the fluid level in the master cylinder. If empty look for leak in system, perhaps a broken brake line or leaking wheel cylinder or caliper. If equipped with drum type brakes, perhaps need adjustment.