10 foot pounds
I was told 7lbs
What is the torque level for the valve cover gasket.
10 ft-lbs. and no more.
The valve cover on a Ford 5.0 engine has a torque of 10 foot-pounds, though this can vary between other models. If possible, locate a service manual, which will list the specs for your particular engine.
Tighten the valve cover retaining bolts in sequence, torque them to 71-106 inch lbs. (8-12 Nm).
The valve cover torque specifications, for your 5.4 liter Ford engine, is 15 pounds per square inch. The bolts should be torqued five pounds at a time.
53-70 in-lbs
The torque converter in a Ford Windstar is located on the side of the transmission at the valve body. You must remove the side cover in order to gain access to it.
The PCV valve on a 2004 Ford Taurus should be on the left side of the engine. It plugs into the valve cover at the rear of the cover.
Valve cover torque spec for 4.0 SOHC is 89 in-lbs. - Haynes Repair Manual #36071. This manual is for Ford Ranger Pick-ups, 1993-2005 models, but DOES include torque specs for the 4.0L SOHC engine.
The torque specification for a valve cover on a Ford vehicle typically ranges from 7 to 15 ft-lbs, depending on the specific engine model and year. It's important to consult the vehicle's service manual for the exact torque value and sequence for your particular engine. Proper torque ensures a good seal and prevents oil leaks. Always use a torque wrench for accurate measurements.
54-70 lb/in NOT foot pounds... www.teamzx2.com