answersLogoWhite

0

how much to replace axles on a 2000 bravada

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you replace fuel injectors on a 2000 olds bravada?

Remove the upper intake.


How do you replace a serpentine belt on a 2000 Bravada?

if you have to ask how to replace the belt you should not open the hood take it to a shop


Where is the fuel filter on a 2000 Olds Bravada?

underneath front door on frame look up.


Where is the oil filter on a 2000 olds bravada?

front pass side up under the car


Can you replace the heater core on a 2000 olds bravada without taking out the whole dash board?

No you must remove the dashboard. I just had it done on a 1996 Bravada and it cost me $450.00.


Where is the speed sensor on a 2000 Olds Bravada Smartrak and how hard is it to change?

The speed sensor on a 2000 Olds Bravada Smartrak is on the top of the automatic transfer case. To change it you need to disconnect the two wires and replace with a new sensor.


How do you replace the fuel regulator on a 2000 Oldsmobile bravada 4.3 liter engine?

it is located inside the intake manifold


2000 oldsMOBILE bravada is over heating SHOULD I REPLACE THEROMOSTAT?

try replacingthe rad cap it worked on mine


How do you replace front wheel bearings on a 2000 Ford Ranger?

how do i replace front wheel bearinbs on 2000 ford ranger 4wd


How do you replace a front turn signal bulb for a 2000 sts Cadillac?

How do you replace a front turn signal bulb for a 2000 sts cadillac?"


Heated seats in a 2000 bravada?

What about them?


How do you replace front axels on 2000 infiniti i30?

To replace the front axles on a 2000 Infiniti I30, first, safely lift the vehicle and remove the front wheels. Next, disconnect the lower control arm and any necessary components, such as the brake caliper and rotor, to access the axle. Remove the axle nut using a socket, then pull the axle out of the hub and transmission. Install the new axle by reversing the steps, ensuring all components are securely reattached and torqued to specifications.