heres the procedure straight from the Ford repair manual
Battery CablesRemoval
All vehicles
To install, reverse the removal procedure
To replace the battery cable on a 2002 Hyundai Santa Fe, first, disconnect the negative terminal of the battery to ensure safety. Next, locate the positive and negative battery cables; use a wrench to loosen the bolt at the terminal ends and remove the old cables. Install the new battery cables by connecting the positive cable first, followed by the negative cable, and tighten them securely. Finally, reconnect the battery and ensure everything is functioning properly.
What type of battery do i need for a 2002 ford focus
jack up paasenger side of vehicle remover tire then remove wheel well disconnect negative cable, positive cable, battery holddown and remove battery installation is reverseal of uninstall
To replace the neutral safety switch on a 2002 Ford Focus 2.0, first, disconnect the negative battery terminal to ensure safety. Locate the neutral safety switch on the transmission, usually near the shift cable. Remove the electrical connector and the mounting bolts securing the switch, then install the new switch by reversing the removal steps. Finally, reconnect the battery and test the vehicle to ensure proper operation.
Tools needed to replace front brakes 2002 Ford Focus?
what is the cost to replace a battery in a volkswagen beetle 2002
It will cost you about $743.00 to replace a vacuum tube on a Ford Focus 2002.
you don't. you replace the whole regulator assm.
To reset the computer on a 2002 Ford Taurus disconnect the negative battery cable. Leave the battery cable disconnected for five to ten minutes. Reconnect the cable and start the car. The computer should be reset.
get a BFH
Disconnect the - battery cable Raise and support vehicle Disconnect wiring at the top of the starter Remove starter mounting bolts Remove starter
To change the battery in a 2002 Cadillac DeVille, first, ensure the engine is off and the keys are removed. Open the hood and disconnect the negative cable (black) first, followed by the positive cable (red). Remove the battery hold-down bracket, then lift out the old battery. Place the new battery in the tray, secure it with the bracket, and reconnect the positive cable first, then the negative cable.