0
What else can I help you with?
What is wrong when the wiper blades do not work on a Chevy Corsica?
wiper motor or the bolts holding it tight.
Should you put radiator cap on tight or loose on your 1996 Chevy S-10 pickup?
The cap should always be installed tight, that is the way the cooling system is designed to work.
Why is your Hyundai accent overheating when the cooling system seems to be working?
Hyundai got excellent cooling system, you might have a little hole in your radiator that affects cooling circulation pressure? check if you have tight cooling system pressure.COCORICO
Where does one find the petcock to drain the cooling system on a 1999 Chevy Tahoe?
The extreme driver's-side bottom corner facing the back. It is located about 2 inches under an aluminum hose fitting....tight area.
How do you remove a 2.8L V6 engine from a 1988 Chevy Corsica without taking the transmission out with the engine?
Yeah it looks tight alright, but after you remove all the accessories, and drive pulleys, you would have just enough room to sneak the engine out of there leaving the transaxle behind.
What is the cause of tight steering at idle with a 2003 Chevy Suburban?
Loose P.S. belt?Low fluid?Weak P.S. pump?Air in System?
Why are you hearing water sloshing under the dash of your 1997 chevy S-10?
Probably air caught in the cooling system. Be sure the small hose between the radiator and the coolant reservoir fits tight and in good condition and that the reservoir is full. The check valve in the radiator cap may also be faulty, replace the cap if in doubt. The system is designed to bleed itself of air if all the components are good.
Where is the valve to recharge AC system located on a 1997 Chevy Monte Carlo?
Should be located down by the battery its kind of tight spot is there a diagram or picture of the port?
How tight do the head-gasket bolts need to be for a Chevy c1500?
how tight should we tight the head gasket bolt for a ford f150 Need to know the engine size.
What does it mean when code p0452 emission control system pressure sensor low on 2000 Chevy s 10?
Start with checking the fuel cap, its condition and if it was on straight and tight.
What is the torque for the half shaft nut on 1997 Chevy Venture?
Tight......like 200ftbls tight I get a long breaker bar and stand on it a touch.
How tight do you tighten the bolts of the valve covers to a Chevy 350?
100 INCH pounds.
