answersLogoWhite

0

Remove the three T-15 Torx screws holding the corner marker light housing in. This will expose two 10mm hex head caps screws. Remove these and the two others on the inboard side of the housing by putting a socket on a long extension through the second slot in the grille. The housing is then unbolted, but a ridge on the inboard side is trapped behind the grille. I loosen the grille and wiggle the housing from the outside edge toward the outside of the vehicle. Then remove the blue wire clip and the terminal. The angled housing will then come out by turning it clockwise in to release the bayonet connection.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

In a 1996 Oldsmobile Cutlass Ciera the low beams work but not the high beams High beam indicator goes on although the high beams do not turn on. Changed the high beam bulbs and the dimmer switch?

try checking ur high-bea fuses and relays


How do you adjust headlights on 1995 Oldsmobile cutlass ciera?

To adjust the headlights on a 1995 Oldsmobile Cutlass Ciera, first park the car on a level surface about 25 feet from a wall. Turn on the headlights and use a tape measure to determine the height of the headlight beam from the ground. Adjust the vertical aim by turning the adjustment screws located at the back of each headlight assembly until the top of the light beam is just below the height mark on the wall. For horizontal adjustment, ensure the beams are centered in a vertical plane with a slight rightward tilt.


Where is the ignition switch located on a 86 Oldsmobile Cutlass Ciera?

It is on the upper left side of the steering column, low down, near the similar looking low-high beam switch. Both of those are manipulated by rods instead of being in the upper column.


How do you change a drivers side low beam headlight bulb on a 1997 Olds Aurora?

Take the light assy off and take the bulbs out the back.


How do you change a low beam on a 92 Cutlass Supreme?

TO CHANGE A LOW BEAM HEADLIGHT YOU FIRST OPEN THE HOOD THERE SHOULD BE THREE PLASTIC GROMETS WITH A REMOVEBLE CENTERD. REMOVE THESE CENTERS AND THE PLASTIC PIECE WILL LIFT OFF. THEN THERE ARE TWO TORX SCREWS THAT HOLD THE HEADLIGHT RING IN PLACE THE OTHER SIDE IS HINGED AND WILL SWING OUT OF THE WAY. YOU MAY HAVE TO USE A SOCKET FOR THIS .


Where is the high beam switch on a 1986 Oldsmobile cutlass supreme?

it the handle on the side of steering wheel chick it towards you or oppsite


How do I change a low beam on a 2004 Chevy Suburban?

change low beam lite in 1999 suburban


What does a flashing high beam light on a 1995 Oldsmobile Achieva mean?

i have a 96 olds achieva and my high beam light was flashing, i checked the headlights and one of my low beam headlights was out. once replaced the flashing stopped.


How do you change out low beam light on 2005 Hyundai sonata?

how to change out low beam on 2005 hyundai sonata?


How do you change the low beam bulb on a gmc sierra 2005?

How do I change the low beam bulb in a gmc sierra 2005?


How do i change a direction of a light beam?

To change the direction of a light beam, you can use mirrors or lenses to reflect or refract the light in the desired direction. Adjusting the angle of the mirror or lens will change the direction of the light beam. Alternatively, you can physically move the light source or the object the light is reflecting off of to change the direction of the beam.


Light beam dimmer is chemical or physical change?

A beam of light becoming dimmer is a physical change since it is reversible. Recharging its source will make the light beam bright again.