answersLogoWhite

0

lower the k member by removing the 2 motor mount bolts, 1 on each side of the block. Make sure to have the motor supported with a lift, and the car elevated on jack stands. Now remove the 4 k member bolts (2 on each side). once this is done you can undo the bolts on the sway bar bracket, and the torsion bars on each side of the vehicles front end. Make sure to support the k member in the center with a jack. Now if the engine is unbolted from the mounts you can raise it about 6 inches with the hoist . you can also lower the k member on the jack. You should no have room to access the oil pan bolts for removal. You will most likely have to remove the 2 bolts on the oil pan pickup, which can be very difficult, so you can remove the pan. This is a moderately difficult job taking about 4-5 hours.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Will 22 rims fit on a 2000 Crown Victoria intercepter without a lift kit?

Yes,with rubber band tires maybe 35,or40


How much horse power does a 2000 crown Victoria police interceptor have?

250


Where is the fuel pump on a 2000 crown vic?

How to change. Fuel pump on 200 crown vic


What is the cooling capacity of 2000 crown Victoria police interceptor?

15.0 Liters / 15.8 Quarts


Top mph of 2000 Crown Victoria police cruiser?

I'm not sure of the 2000, but a 1997 is governed down to about 128 mph.


What is the fuel capacity of a 2000 Ford Crown Victorian Interceptor?

On a 2000 Ford Crown Victoria : The fuel tank holds ( 71.9 litres / 19.0 U.S. gallons ) Civilian and Police versions


Fuse layout for 2000 crown vic police car?

Click on the link below Click on Owner Guides The 2000 Crown Vic. owners manual ( which includes the fuse panel diagram ) can be viewed on-line


Where is the oil pressure switch in a 2000 ford crown Victoria?

On a Police Interceptor model, it is just under the oil filter.


What grade oil for 2000 Crown Victoria?

5 W 30 - according to the 2000 Ford Crown Victoria owners manual ( 5 quarts / 4.7 liters with filter change )


How do you change the fuel filter on a 2000 Ford crown vic 4.6V8?

you have to drop the fuel tank. the pump is inside.


What is the oil capacity of a 2000 Ford Crown Victoria police interceptor 4.6L engine?

Should be around 4.5 L unless it has an oversize oil pan.


How much oil does a 2000 ford Crown Victoria take?

According to the 2000 Ford Crown Victoria Owner Guide : With engine oil filter change : ( 4.7 litres / 5.0 U.S. quarts of 5W-30 engine oil )