0
If it is anything like the 01 it is located under the glove box. Remove plastic cover panel by pushing in on the two clips and dropping it down. On my 01 there was a plastic clip back towards the motor a little. Just pull down and it should release. I also removed the door to the glove box to add visibility. There is three screws holding to the shroud. There was also a wiring harness clip that I just broke off to get out the way. Better if you can unclip it. It is a pain to access when you weigh 350 and try to get in there.
What else can I help you with?
How do you get to the Heater Blower motor on a 2000 Chevy impala?
down uner the glove box
Your 2000 Chevy Impala the blower motor only works sometimes what could it be.?
Loose connection or blower motor is bad
How do you change blower motor on 2000 Chevy blazer?
how to change the blower motor
Where is the Blower Motor Resistor Pack located on a 2000 Chevy Impala and how do you change it?
There is a removeable panel below the glovebox. It is in front of the blower motor against the firewall. It has a wire connector from the loom and then it plugs into the blower motor
How do you change the turn signal switch in a 2000 Chevy Impala?
it is cool
When do i change my transmission fluid on my 2000 Chevy impala?
They recommend 30,000 miles.
How long does it take to change a starter in a 2000 Chevy impala?
32.8 sec.
How do you change bulb on instrument panel of 2000 Chevy Impala?
you cannot service panel lights on 2000 impala . you hav to replace the instrument cluster.
What will cause the fan blower motor cruise control and running lights not to operate in a 2000 Chevy Impala?
check the fueses check fueses
What are the stereo color codes on a 2000 Chevy impala?
2000 chevy impala sterio wireing color codes
What are the torque specs for a 2000 Chevy Impala 3.8 liter?
What are the torque specs for 2000 Chevy Impala 3.8 Litre ?
What is the proper wiring for a 2000 Chevy impala 3.4L starter?
what is the proper way to wire the starter for a 2000 chevy impala
