MASS AIR FLOW SENSORS NOT RECAMENDED TO CLEAN SOME CAN BE AJUSTED
You must remove the MAF from the air intake hose. Then, where the air flows through, inside you will see a small wire, this is a resister. Spray CRC MAF cleaner inside, cleaning the grid as well as the resister . Let it dry for about 15 to 30 minutes, it doesn't take that long but better safe than sorry, then reinstall the MAF sensor. Remember to plug it back in to the system. Be sure and put a dielectric in the plug before plugging it back in.
The best cleaner to use is is CRC Mass airflow cleaner, because it is less abrasive. You must be careful what you put on it, you can destroy the resister, and most MAF cost 200.00 and up, so be careful there.
its on the air filter housing
Carburetor cleaner will do the job.
You can use brake cleaner to clean mass air flow sensor, ensure air filter is not clogged and sensor does not need replacement. What are symptoms?
On a 2002 Ford Ranger : The Mass Air Flow Sensor is between the engine air filter and the engine air intake tube
It does not have a mass air flow sensor.It does not have a mass air flow sensor.
How to locate and clean or replace mass air flow in Mercedes ml320
It does not have a mass air flow sensor.
A 1999 Chrysler Sebring does not have a mass airflow sensor.
how do you clean mass air flow sensor on a 1998 Nissan altima? To clean the mass air flow sensor , you need to get a can of CRC mass air flow cleaener frm auto zone, Kragen, Pepboys, Sensor is attached to the tube (next to airfilter). again you need to use mass air flow cleaner ( CRC ). I use this on my ford windstar and Nissan sentra 05 and 95. it runs better after cleaning the mass air flow sensor.
vacuum leak
check with your dealer,i have a 1999 v70 wagon.there was a recall and the dealer fixes it for nothing,good luck
It can not be cleaned. Trying to clean it will mess it up.