How to fix axle leaks on 95 Chevrolet PU with full floating HD rear end changing seal hasn't solved?

Answer 1

You need to remove axel and hub assy. again. And look at where the seal rides on the axel housing itself. they make a seal repair sleeve that drives over the axel housing to fix this problem. Clean and sand housing real good before you install sleeve. Need to check VENT TUBE on rear end housing to make sure its open and not stoped up. pull rubber hose off. You should be able to blow through it , but not suck thrugh it. Make sure the medal tube that the hose goes on is open too.

When you add gear oil , don't fill it up to the fill hole, keep it about 1/2 inch below

the fill hole.

If Your sure this is a true full floating rear end then this will fix it.

Be sure to use GM FACTORY SEALS ONLY