get a floor jack and a block of wood and jack up the motor from the oil pan then get a socket and take out the two bolts move it around till it drops out and remove the two wires. same to put it back in
You can replace the starter, on your 1994 Chrysler town and country Van, by removing the starter wiring. Remove the three retaining bolts. The starter will come off. Reverse the process to install the new starter.
remove the neg battery cable then the wires on the starter. Then take out the mounting bolts and work the starter out.
Do you mean the starter solenoid? It's the part of the starter where the wires are bolted on. You'll have to remove and rebuild the starter.
Hey George===First remove the negative battery cable. Rme ve the flywheel cover. Then remove the bolts holding the starter to the block. Drop the starter down enough to remove the wires. then remove the starter. GoodluckJoe
1994 ford aerostar starter removal . raise vehicle/disconnect battery cables/ starter is on driver side remove wires from starter/ remove bolts holding starter to bellhousing.installation is reverse of removal piece of cake.from Robert rodriguez. You may need to remove the exhaust "Y" pipe to replace the starter, also. On AWD models this is mandatory. I recommend that you soak the bolts in Liquit Wrench before trying to loosen them.
Disconnect - battery cable Raise and support vehicle Disconnect wiring from starter Remove mounting bolts Drop starter
The solenoid is on the side of the starter or built into the starter
You have to remove the exhaust pipe from exhaust manifold on starter side. Now you have access. Get exhaust pipe to exhaust manifold gasket first, you will probably need to replace it after taking them apart.
NO very easy actually, remove Battery Cable,H-Pipe, 2 bolts and 2 wires.
Remove - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
To replace the starter on a 1994 Chevy S10, first disconnect the negative battery cable to avoid any electrical shorts. Then, locate the starter, which is typically found near the transmission on the driver's side. Remove the mounting bolts and disconnect the wiring harness from the starter. Install the new starter by reversing the removal steps, ensuring all connections are secure before reattaching the battery cable.
Remove the positive battery cable from your 1994 Firebird battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install your new starter.