Disconnect the ground wire from the battery before beginning any work on the dash. The instrument cluster is removed from the front of the dash. You will first need to remove the wood looking trim plate on the left side of the steering column by gently prying off. It is held in place by plastic keepers and is somewhat fragile. Then gently pry off the plastic air conditioning vent just above the wood trim plate. you should then be able to see a small screw that holds the plastic trim plate that extends from the left side of the dash all the way across to just beyond the radio. Lower your steering column and gently pry off this entire trim plate. It is fragile so go slow and be careful. You will need to unplug the module that controls the gauges and gas info. Once the trim plate is removed you can see the instrument cluster clearly and see the screws that hold it in place.
passenger side under dash. cover has to be remove to see it
start by taking the door panel off ....
To remove the instrument panel from a 2004 Buick Rainier, start by disconnecting the battery to prevent any electrical issues. Next, remove any screws and clips securing the trim around the panel, then carefully pry it away. After that, unscrew the instrument panel itself from the dashboard and disconnect any electrical connectors. Finally, gently pull the panel out, taking care not to damage any surrounding components.
The PCM is located on the right side (inside) behind the instrument panel near the shroud
Remove the instrument panel cover. Remove the instrument panel retaining screws. Remove the wiring harness from the gauges. The instrument panel will come out.
The turn signal flasher is located under the left hand of the instrument panel, right of the steering column.
how do you remove left rear door panel on a 2008 buick lucerne cxs.
To replace the instrument panel lights in a 1994 Buick Regal, first ensure the vehicle is off and disconnect the negative battery cable for safety. Remove the instrument panel by unscrewing the screws that secure it, then carefully pull it out to access the bulb sockets. Twist the bulb sockets counterclockwise to remove them, replace the old bulbs with new ones, reassemble the panel, and reconnect the battery cable. Finally, test the lights to ensure they are functioning properly.
It's located under the left hand of the instrument panel,left of the steering column. It's a 16 pin connector.
Right side of dash...remove the kick panel and the fuse block is up in the dash.
remove plastic around instrument panel . remove screws from instrument panel then pull panel towards you to unplug it this will allow to get to dach lights
How do you remove the instrument panel in a 1998 Ford Expedition 5.4 Engine