Open the front lid and reach into the opening and find the cable loop. Pull hard on it and it will release the spring loaded pins that hold it into place.
good Luck
Remove the bolts holding the console down and remove.
Remove the center console. The module will be in front of console under dash
To remove the center console on a 1994 Chrysler LeBaron, start by disconnecting the negative battery terminal to ensure safety. Next, remove any screws or bolts securing the console, typically located in the front and rear. Carefully lift the console up and out, being mindful of any electrical connections for the gear shifter or accessory outlets. Once disconnected, you can fully remove the center console from the vehicle.
If you need to just remove the tray from the front console, there is a spring loaded button on the top side in the center of the tray, at the back, just push down
97 Chrysler town & country evaporator bolts location for removal
The drain plug is turned counter clockwise to remove it on a 2003 Chrysler Town and Country.
To remove the center console on a 2007 Chrysler Pacifica, start by disconnecting the negative battery cable to ensure safety. Then, remove any screws or bolts securing the console, which are typically located in the storage compartment and underneath or behind the console. Carefully disengage the console from its clips and connectors, and lift it out gently. Be cautious of any wiring or cables connected to the console, and disconnect them as needed.
The center counsel on a 2007 Chrysler Sebring can be removed by loosening the bolts on the bottom of the Council. The bolts are located at the back of the Council.
To remove the spare tire there will be a little flap of carpet in the rear of the van. behind the 3rd row seats.Lift that up and use your lug wrench to lower the tire.
You will need to jack up the Chrysler Town and Country Van to remove the spare tire. It can be found underneath the van between the driver and passenger seats.
To remove the center console on a Chrysler 300, start by disconnecting the negative battery cable for safety. Next, carefully pry off any trim pieces around the console and remove screws or bolts securing it to the floor and dashboard. Once all fasteners are removed, lift the console gently, disconnect any electrical connectors, and pull it out of the vehicle. Always refer to the specific model year’s service manual for detailed instructions and any additional steps.
Remove the fuel tank.