0
Autozone.com has a great how to if you follow this link.
http://www.autozone.com/az/cds/en_us/0900823d/80/0b/af/87/0900823d800baf87/repairInfoPages.htm
I have to replace mine, and have it apart. Maybe you can help me. If you know of a place where I can buy just the seal. E-mail me at joshua.s.mendez@us.army.mil if you have any questions or know where i can get the seal
What else can I help you with?
How do you replace blend door actuator motor on 1999 ranger?
how to replace a blend door actuator on a 1999 ford ranger
How do you replace the rear axle on a 1999 ford ranger?
To replace the rear axle on a 1999 Ford Ranger, start by safely lifting the truck and securing it on jack stands. Remove the rear wheels and brake components, then disconnect the driveshaft, brake lines, and any suspension components attached to the axle. After supporting the axle with a jack, remove the mounting bolts, and carefully lower the axle from the vehicle. Install the new axle by reversing the removal steps, ensuring all components are properly reconnected and torqued to specifications.
Were is speed sensor on 1999 Ford Ranger manual transmission?
its on the rear axle housing
How do you replace oil pump in 1999 Ford Ranger xlt ext cab 4x4?
how to replace oil pump in a 1999 ford ranger xlt ext cab 4.0
How do you replace rear bearing on 1997 Ford Ranger?
you will have to have the axle pulled at a shop.the bearing slides along the axle shaft and seats in the axle housing.
Where is the speed sensor located at on a 1999 ford ranger 6 cylinder?
rear axle housing
What is the rear end gear ratio of a 1999 Ford Ranger with axle code 86?
I ASSUME axle code " 86 " is the same as it is on the ( 1996 ) Ford Ranger ( 3.73 gear ratio , conventional / non - limited slip )
Replace water pump on 1999 Ford Ranger?
very carefully.
When should the timing belt on your 1999 Ford Ranger be changed?
Inspect at 120,000 miles , replace if needed ( Ford maintenance and the Gates website ) for the 2.5 liter , 4 cylinder , in a 1999 Ford Ranger
CV boot Ford Ranger how to replace?
A CV boot is found on the axle of a vehicle. To replace the outer boot remove the axle bolt and pull the boot off. The inner boot requires removal of the whole axle.
Where is the axle ratio code on a 1999 Ford Ranger?
open the drivers door , and on the end of the door will be information stickers the axle code will be shown on one of the stickers
1999 Ford ranger 3.0?
You have a 1999 Ford Ranger 3.0.
