answersLogoWhite

0

Buy the Haynes repair manual, look under ignition switch removal. Follow the directions and they will get you to where the switch is visible, remember its not the key part but the slide switch between the key switch and the dash. Getting to the 2 screws that hold it to the column requires patience and a torques head bit and quarter inch socket and ratchet. Somewhere along the line you might run into a torques security head ( has a pin that mates into a hole in the torques head bit). Remember the sequence because about every 3 years you will be replacing the switch. An emergency repair to get you down the road can be done with a pair of needle nosed pliers to bend the metal tabs back over where they are separating and letting the unit spread apart. Careful when you take the switch completely loose! I had one pop apart and springs, slide bars and pins flew everywhere. Put key switch in run position at start of removal, the replacement switch should be in that position so they will go together easily.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you replace the water pump on a 1992 Mercury Topaz?

what is the engine?


How do you get the second bolt out of the power stering pump to remove the entire pump?

how do you replace a power steering pump on 1992 mercury topaz


How many fuel injectors on a 1992 Mercury Topaz?

4


What is the firing order for a 1992 Mercury Topaz 2.3 l engine?

how to set timing on 92 ford mercury topaz 2.3 engine


Where is the PCV valve on a 1992 mercury topaz?

It is positioned in the valve cover.


What is spark plug gap on 1992 2.3l mercury topaz?

According to one of Fords websites : For a 1992 Mercury Topaz , 2.3 litre four cylinder engine : ( the spark plugs are gapped at .054 inch )


How do you change the fuel pump relay on a 1992 Mercury Topaz?

location fuel pump relay 92' merc topaz


How Do You Replace Ignition In 1992 Cavalier?

how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder


Location of ignition fuse mercury topaz 1992?

Not quite sure what you are looking for? Do you mean ign. module? Like you have no spark? yes no spark or very little.....car motor turns but will not start


How do you replace ignition switch on a 1992 Pontiac Bonneville?

How do you replace the ignition swith opn a 1992 Pontiac Bonneville se


Where is the fuel pump located on a 1992 Mercury Topaz 3.0 liter V6?

In the gas tank.


1992 Mercury Topaz spark plug firing order?

The firing order for a 1992 Mercury Topaz, which is equipped with a 2.0L or 2.5L engine, is 1-3-4-2. This sequence is crucial for the proper operation of the engine, ensuring that each cylinder fires in the correct order for optimal performance. If you're working on the ignition system, it's important to follow this firing order for accurate timing and engine function.