0
First you must remove the transmission. This can be achieved by removing the drive shaft. Then The two torque strut bars located at the from of the transmission. and followed by the other bolts that hold the transmission to the engine. The slave cylinder is on the spline of the area where the throw out bearing is located right up front in your face "THERE" it look s like a litle thermostate with two pig tails. You must remove this from the shaft and and replace every thing back in this order. Once done you can bleed off the cluch simply by pumping the pedal as you add more fluid to the resivoir located at the drivers side off the fire wall in the engine compartment.
What else can I help you with?
How do you change a clutch slave cylinder on a 1988 Chevy S10 Pickup?
You will need to remove the transmission to replace the clutch slave.
How do you adjust the clutch on an 89 Chevy 2500?
You can't, there is no adjustment. Time to replace clutch, slave cylinder or clutch master cylinder. 1 of the 3.
How do you replace slave cylinder on Chevy Tracker 2002?
To replace the slave cylinder on a 2002 Chevy Tracker, first, ensure the vehicle is securely lifted and supported. Drain the clutch fluid and remove the clutch line from the slave cylinder. Unbolt the slave cylinder from the transmission bell housing and carefully remove it. Install the new slave cylinder by reversing the removal steps, ensuring all connections are tight and then refill the clutch fluid before bleeding the system.
How do you replace the clutch slave cylinder on a 1989 Jeep Wrangler?
How do you replace the clutch slave cylinder on a 1989 jeep wrangler
How do you replace the slave cylinder on a 1995 dodge neon clutch?
How do you replace a slave cylinder on a 1995 dodge neon clutch
How do you adjust the slave cylinder on a 1989 Chevy pickup 1500?
There is NO adjustment, You must replace the clutch set to bring the pedal back to the right position. You also need to make sure the clutch slave cylinder/ master cylinder is good before replacing clutch assy.
How do you change hydraulic clutch in 99 Chevy s10?
Which part do you want to replace? The slave cylider or the master cylinder? The hydraulic line and master cylinder.
How do you remove and replace the clutch cylinder on a 1999 Chevy s-10?
To replace the slave cylinder on this vehicle you will have to remove the drive shaft and then the transmission. The slave cylinder will be bolted to the inside of the bellhousing. The transmission is very heavy so be very careful.
Should you replace your clutch master cylinder when replacing clutch?
At least the slave cylinder. The clutch master cylinder can be replaced at any time.
How do you replace the slave cylinder in 96 Chevy C1500?
How do you replace a slave cylinder in a 96 chevey k1500
What if your clutch on your 85 Toyota corolla goes to the floor and is hard to shift?
There are two normal causes. The clutch is worn out or there is a leak in the hydraulic clutch slave or master cylinder. To check the clutch, press the clutch slave cylinder down. If the clutch slave cylinder bellows compresses down to the slave cylinder, the clutch is worn out. Check the clutch master cylinder fluid level. if this is low, then the clutch cylinder need to be checked. To check for a hydraulic leak in the clutch slave cylinder, remove the cylinder's bellows and check for any fluid. If fluid is present, rebuild or replace the cylinder and bleed the system. To check the clutch master cylinder, check the back the of clutch master cylinder for leaks. If fluid is present, replace or rebuild clutch master cylinder and bleed the system. In my experience, hydraulic leaks occur at the clutch slave cylinder.
If i replace slave cylinder will that make my clutch disengage and engage correctly?
if i replace slave cylinder in 1994 Honda civic ex will this make my clutch disengage and engage correctlyanswerchange master cylinder and slave properly then bleed the system properly.
