0
To replace the engine coolant temperature sensor on a 1998 Oldsmobile Achieva, first, ensure the engine is cool and disconnect the negative battery cable. Locate the sensor, which is typically found near the thermostat housing or cylinder head. Unplug the electrical connector, remove the old sensor using a socket or wrench, and install the new sensor after applying a small amount of thread sealant if required. Finally, reconnect the electrical connector and the battery cable, and check for leaks or any issues.
What else can I help you with?
How do you replace a heater core in a 1998 Oldsmobile achieva?
how do you get to it
How do you replace the radiator on a 94 Oldsmobile acheiva s?
How do you replace an 1994 3.1 Oldsmobile Achieva s radiator?
How do you bleed cooling system 96 olds achieva?
To bleed the cooling system on a 1996 Oldsmobile Achieva, first ensure the engine is cool. Remove the radiator cap and start the engine, allowing it to reach operating temperature. As the thermostat opens, air bubbles will escape; keep an eye on the coolant level and add more if necessary. Once the bubbles cease and the coolant is at the proper level, replace the radiator cap securely.
How to locate and replace crankshaft sensor on 1996 Oldsmobile Achieva 2.4 liter engine?
did u ever figure it out?
How do you replace the water pump on a 1995 Oldsmobile Achieva?
is it hard to change the water pump on a 1992 Oldsmobile achieva. Yes, it is very hard to replace a water pump on an Achieva. When the pump died on my 1996 Achieva, the engine needed to be unbolted and removed to get to it. As I recall, it cost about $500. I have a 95 Olds Achieva 3.1 and the water pump was very easy to change. Mine is on the front passenger side of the engine. Very easy to get to, just be careful not to break any bolts off. lol
How to replace the radiator fan switch on a 1992 olds Achieva?
1992 olds Achieva does not have that switch. ECM receive signal from the coolant temperature sensor and send command to relay #6 for turn on/off the radiator fan. Relay #6 is located in the motor compartment on the fireboard.
Where is the fuel filter located on a 1995 Oldsmobile Achieva?
Back by the fuel tank itself, look around and it is easy to get and replace
How do you replace the head gasket on a 1996 Oldsmobile Achieva?
To replace the head gasket on a 1996 Oldsmobile Achieva, start by disconnecting the battery and draining the coolant. Remove the intake and exhaust manifolds, along with any necessary components like the timing cover and belts to access the cylinder head. Carefully unbolt the cylinder head and remove the old gasket, ensuring the surfaces are clean before installing the new gasket. Reassemble everything in reverse order, torqueing the bolts to the manufacturer's specifications.
How do you replace the electrical ignition switch on a 1995 Oldsmobile achieva?
To replace the electrical ignition switch on a 1995 Oldsmobile Achieva, first disconnect the battery to ensure safety. Remove the steering column covers, then locate the ignition switch, which is typically mounted on the steering column. Disconnect the wiring harness from the old switch, unbolt it, and replace it with the new switch. Finally, reassemble the steering column covers and reconnect the battery.
Change brake pads on 1994 Oldsmobile Achieva?
Changing brakes is a simple task. Lift the car, remove the wheel, remove the brake shoe, replace the pad, replace the shoe, replace the wheel and lower the car.
How do you replace the alternator on a 1996 Oldsmobile Achieva?
Gene Snitsky went from the WWE, to ECW to RAW to Total NonstopAction Wrestling to doing Walking Dead horror films.
Where is the water pump located on a 1994 Oldsmobile Achieva?
2.3L quad 4 is located under the exhaust manifold passenger side. To replace you have to remove the exhaust manifold.
