answersLogoWhite

0

There's a plastic ring around the bulb you can remove and then twist out the base holding the bulb. Then change the bulb and twist it back in followed by the retainer ring. It's really simple (for a change). The rear spark plugs are a different story.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you replace a heater core on a 1994 Buick park avenue?

I need to know how do i replace a haeter core on a 1994 buick park avenue?


How to replace a serpentine belt on 1994 buick lesabre?

replace tension put it on


How do you change headlamp on 2006 buick lucerne?

To change the headlamp on a 2006 Buick Lucerne, first, open the hood and locate the headlamp assembly. Disconnect the power connector by pressing the tab and pulling it out. Remove the headlamp assembly by unscrewing the retaining screws, then carefully pull the assembly out. Replace the old bulb with a new one, reassemble the headlamp by reversing the steps, and ensure everything is secured before closing the hood.


How do you Replace bumper on 1994 Buick century?

Take it to a body shop.


How do you fix a valvecover gasket in an 1994 Buick LaSabre?

Replace the gasket.


How do you replace a wheel bearing on a 1994 Buick LeSabre?

AnswerFront or rear?front


How do you replace a fuel filter on a 1994 Buick Roadmaster?

drop the gas tank


How to replace a starter on 1994 Buick regal coupe 38 L V6 turbo with air?

AnswerHow to replace starter for 1996 Buick Regal #.8 Liter 6cyl


How do you replace the water pump on a 1994 Buick Skylark?

you have to take the timing chain off


How do you replace the coil on a 1994 Buick Roadmaster?

Ignition CoilEngine LH Side Upper


How do you replace a headlamp relay in a 1994 Jeep Wrangler YJ?

I believe there is no relay in the 94 YJ.... the power is regulated throught the switch.


How do you replace a rear wheel bearing on a 1994 Buick LeSabre?

I have a shimmy or small vibration while driving the interstate on my 1994 buick lesabre - if i was to check the front and rear bearings - how would i do that and what would i look for