0
To access the fan switch on the multifunction switch assembly (MFSA) you first have to remove the instrument panel (IP) accessory housing. This housing is made of plastic and goes around the front edges and around the sides of the car radio and MFSA.
To remove the IP accessory housing:
1. Open the ashtray or cupholder and remove two screws from the front of the housing.
2. Remove the two screws from the bottom of the housing. These bottom screws are accessible only after removal of the console storage box.
To remove the console storage box:
1. Open the storage box door and empty all contents.
2. Remove two screws on the front side wall of the box.
3. Slide the console storage box back and then to the passenger side of the vehicle for easy access to the bottom the the IP accessory housing.
To remove the fan switch from the MFSA:
1. Pull the fan switch knob out of the MFSA.
2. Remove the two screws holding the MFSA to the IP.
3. Remove the left electrical connector attached to the fan switch on the back of the MFSA.
4. Remove the one screw on the back of the MFSA that holds down the fan switch.
Replace fan switch and reverse above procedures.
What else can I help you with?
Replace switch that control fan speed for vent in Chevy silverado?
Change blower fan control switch in the dash
How do you replace ac condenser on a 2001 Chevy Venture?
How do you replace ac condenser on a 2001 chevy venture?
Where is the heater resistor located on a 2000 Chevy Venture van and were is the best place to buy a fanac control switch?
resistor usually located by blower motor.blower only works on low or high,then replace resistor .do not replace hvac unit in dash waste of time and money
How do you replace blower switch in 2003 Chevy Trailblazer?
To replace the blower switch in a 2003 Chevy Trailblazer, first disconnect the negative battery terminal to ensure safety. Remove the dashboard panel surrounding the switch by unscrewing any screws and gently prying it off. Disconnect the wiring harness from the old blower switch, then remove it from the dashboard. Install the new switch by reversing the process, reconnecting the harness, securing the panel, and finally reconnecting the battery.
How do you replace the blower motor on a 1994 Chevy lumina euro?
How do you replace the blower motor on a 1994 chevy lumina euro?
Why does the blower stay on when my 99 Chevy venture is off?
A common cause for this is a burned out blower resistor. Tech JK --------------------------
What list of things should you check on 2002 Chevy blazer before you replace the blower motor?
The fuse. The blower motor speed resistor. The blower motor relay. The blower motor switch. Check for power at the blower motor connection.
What would cause heater quit working on 1977 Chevy Camaro?
Check fuse if the blower is not working. If it is then replace your heater core. if its not then replace your fan switch.
Where is blower motor on 2001 Chevy blazer motor and how do you replace it?
where is the blower motor on a 2001 chevy blazer
How do you replace a heat blower switch for fan speed on a Chevy 05 Colorado?
To replace the heat blower switch for fan speed on a 2005 Chevy Colorado, first disconnect the negative battery cable to ensure safety. Remove the dashboard panel surrounding the climate controls by unscrewing it and carefully prying it off. Disconnect the wiring harness from the old blower switch, then remove it and install the new switch by reversing the process. Finally, reconnect the wiring, reattach the dashboard panel, and reconnect the battery.
How do you change the driver side window motor on a 99 Chevy venture?
I would try the window switch first , but if you are going to replace the switch then you will see how to replace the motor. You would have to take the door panel apart after that its easy.
Remove windshieldrear motor on a 2001 Chevy Venture?
replace rear window wiper motor on 2001 Chevy venture
