first jack the chaulk the back wheels, then jack up the front end and place it on jack stands, next remove the bolts from the transmission pan and drain the tranny fluid, then proceed to remove the wheel on the side that needs relacing, separate the ball joint and pull the axel shaft out of the transmission, replace eith new axel shaft and reverse the directions to put it back together, don't forget to top up the transmission with fluid...
To replace the lower front ball joint on a 1990 Dodge Colt, first, lift the vehicle and remove the wheel for access. Then, disconnect the brake caliper and rotor, and unbolt the steering knuckle from the control arm. Remove the old ball joint by pressing it out or using a ball joint separator tool, and install the new joint in the reverse order, ensuring everything is properly torqued and reassembled. Finally, reinstall the wheel and lower the vehicle to the ground.
1342
It is not a direct fit.
cant repair a Catalytic converter only replace at a muffler shop
the 2.4 liter engine is 1,3,4,2
Computer is toast
I believe it is located under the distributor cap. At least that's where it is located on a 1991 dodge colt 1.5 litre.
hi, i need know in that place of internet i found the complete dash to my car, is a Dodge Colt STD year 1991 hatchback 2 doors, the dash of my car is very brocken and ugly, i live in San Jos
I have a 93 Dodge Colt GL with the 1.8L engine and automatic transmission. The fuel pump relay is located behind the radio in the center console.
I believe only Ford uses them.
Replacing the front left and right CV joint axles on a 1987 Dodge Colt DL 1.5L typically takes a mechanic about 2 to 4 hours. The time can vary based on the mechanic's experience and the condition of the vehicle. Factors like rust or corrosion may also affect the time required for the job.
Dodge Colt was created in 1970.