0
How to replace the upper intake manifold gasket in a 2000 Ford Taurus - Mercury Sable with a v6 DOHC 24 valve engine?
Very straight-forward procedure.
- Disconnect the EGR valve - 2, 10mm nuts
- Disconnect the rubber air intake tube (5/16ths nut driver?)
- I don't think you need to disconnect the throttle cables, but easy enough to figure out if you have to
- Remove the 6, 8mm bolts upper intake bolts
See "Related Questions" below for more as many of us find that removing the intake plenum really helps when changing the rear sparkplugs - so there's some good detail in that question too.
There are six bolts holding it down. should be 8mm. just take em off and you might want to remove the air hose (5/16ths nut driver/socket) if you intend on moving it out of the way.
The EGR Valve will also not let you pull it so just take off the bottom two nuts...those should be 10mm. good luck
What else can I help you with?
How do you replace the ignition coil on cylinder 3 on a 2000 Ford Taurus?
if it is a dohc engine then you may have to remove the intake manifold
How do you replace the intake manifold 1997 mercury grand marqie?
To replace the intake manifold on a 1997 Mercury Grand Marquis, first, disconnect the battery and remove any components obstructing access, such as the air intake and throttle body. Then, drain the coolant and remove the intake manifold bolts using a socket wrench, carefully lifting the manifold off the engine. Clean the mating surfaces, apply a new gasket, and install the new manifold by reversing the removal process, ensuring all connections are secure and the system is properly refilled with coolant before starting the engine.
How do tell whether your Mercury Sable or Ford Taurus is dual overhead cam or not?
The Mercury Sable and the Ford Taurus will have DOC in printed on the engine if they are dual overhead cam engines. The symbol should be on the top of the engine.
Where are spark plugs on Ford Taurus 2007?
in the front and back of the engine directly above the exaust manifold
Where is the intake manifold on a 1997 mercury villager?
The Villager has an upper and lower intake manifold. It is at the top of the engine with the throttle body attached to it.
How do you get enough slack in the belt to get it back on the engine of a 2002 Ford Taurus?
remove engine....move...replace engine
How do you Replace crankshaft on 1999 mercury villager?
You don't, you replace or rebuild the engine.
How do you Replace the speed sensor on a 2002 Ford Taurus with a V6 engine?
where is the speed control senor located on a 2002 ford taurus
Do you have to remove the intake manifold to change the bypass hose on a 1997 4.6 Mercury Marquis?
No, not for the hose but, I have seen the metal bypass tube that the hose connects to, rust out and cause a coolant leak out the back of the engine. The intake manifold would have to be removed to replace that metal tube.
What does it mean by your Ford Taurus Mercury Sable engine is running lean?
Could be sucking air into intake.
What Nissan part number would you need to replace the rear exhaust manifold on a 2000 mercury villager 3.3 engine?
Nissan isn't going to stock any parts for this, try Rockauto.com or eBay.
Can you replace lifters in a 302 Ford engine without removing the intake manifold?
no.
