You have to put the key into the on position...wait about 15 mins until the theft sys light stops blinking. turn the car off for about a minute and the car should start right up. If you have to do this over and over again every time you have to start your car up it either means your control panel or your ignition is going bad.
wish i would have known what was going on before i paid $350 to have the ignition system changed. Now i have the light on all the time , not sure if syetem works
When I replaced the speedometer cluster in my 96 grand am. My car would not start, as the anti-theft system kicked in. This will happen if you change or replace anything electrical involving the instrument panel. So, yes you do put the key in the start position, and the car will not start, then just leave the key in the the ignition. do not remove it. You will see the anti-theft warning flashing. Wait about 10 minutes. the flashing should have stopped. Take the key out. Wait one minute. proceed to start engine. It should start!
how to reset the antitheft alarm system in a 1996 Chrysler town&country lxi
Unplug the battery for a few minutes, pos and neg posts. This will reset the system.
I would consult either the manual, or you nearest Cadillac dealership :).
To disable the antitheft system on a 1996 Ford Taurus, you can typically try unlocking the driver's side door using the key or the key fob. If the system remains activated, you may need to disconnect the battery for a few minutes to reset the system. Additionally, checking the owner's manual for specific instructions or consulting a professional mechanic can provide further assistance. However, be cautious, as tampering with the antitheft system can lead to unintended consequences.
To reset an anti-theft system in the a 1996 Grand Am, you will need to find the box and turn it off and back on. The anti-theft box is usually located under the dashboard.
Dodge does not use a fuel pump reset switch. The fuel system is computer controlled with relays.
You can not bypass or disable the factory alarm. It is part of the computer programming.
this sounds fishy .... Did you screw that motor up ?
Chevrolet does not use inertia/reset switches.
´90-´90´90
There is no reset on a 1996 Chrysler Sebring.There is no reset on a 1996 Chrysler Sebring.
Reset the battery by removing the cables and reattaching to the terminals - simple