0
What else can I help you with?
What is the horsepower of a Cummins M-11 Engine?
Depends on what it is set at just guessing anywhere from 330 to 500
Dose turning the fuel screw on a 12 valve cummins hurt your motor?
Turning the fuel screw on a Cummins will determine the fuel flow tot he engine. If the screw is set too high of low then the engine will not run properly and could cause engine damage.
Why is the service engine soon light on on a 5.9L Cummins?
Because the computer has detected an emissions related malfunction and set a code.
What is the tappets set at on cummins 6bt Engins?
tappet clearance 6bt cummins
How do you re-set the check engine light on a 2007.5 Dodge 6.7 Cummins Diesel engine?
A scan tool is required to clear the check engine light. If the failure is not repaired, the light will return.
2004 dodge 2500 cummins coolant capacity?
Will vary with different engine and vehicle set-up types. Refer to owners manual.
How do you set max rpm on Cummins L10 diesel?
You need the Cummins Insite software in order to do this.
How much mm tappet clearance of Cummins K38 Engine?
The tappet clearance for the Cummins K38 engine is typically set at 0.25 mm (0.010 inches) for both intake and exhaust valves. It's important to check the specific service manual for the exact specifications, as they can vary based on the engine configuration and application. Proper adjustment is crucial for optimal engine performance and longevity.
What is the gap on the valves on a 2004 5.9 cummins and how do you set them?
The valve clearance for a 2004 5.9 Cummins engine is typically set at 0.010 inches (0.25 mm) for the intake valves and 0.020 inches (0.51 mm) for the exhaust valves. To set the valve clearance, first, ensure the engine is cold. Rotate the engine to the top dead center (TDC) of the compression stroke for the cylinder you are adjusting, then use a feeler gauge to measure the gap and adjust accordingly using the rocker arm adjuster to achieve the specified clearance.
Why do some duramax or cummins diesels blow black smoke out of the exhaust?
Their injection pump is set too rich, and lets more diesel into the engine than the engine can burn. The partially/badly burned diesel is what comes out as black smoke.
How do you set injectors on cummins n 14 celect plus?
if you have to ask you should not be touching them
Why does your cummins engine overheat?
Could be low coolant, but most diesel motors are set to shut down if that occurs. You could have broken a fan belt, you could have a bad thermostat, or a bad water pump. The engine fault codes might be able to pinpoint it for you, as well.
