0
your question is not very clean on your exact problem. I do know that saturns do have the tendancy to "Lock" the steering wheel to the point you cannot turn the ignition key. to remedy this, move the wheel back and forth with force while turning the key, sometimes the lock pin can get bound up in the steering column and prevent the key from turning.
What else can I help you with?
Is a 2000 Saturn SC1 a sports car?
Yes. The sc1 is a coupe.
What is the code to unlock the CD player on a Saturn SC1?
how do i get the code to unlock stock cd player on 1996 saturn
How do you change a ignition lock on a 1994 Saturn SC1?
http://youtube.com/watch?v=D3o4IuScZZI
How do you change the wiper motor on a 2002 Saturn SC1?
How to remove the wiper motor on a 2002 Saturn sc1
Why would your ac in your 2000 Saturn SC1 blow hot air?
you might need to refill the freeon
1995 Saturn SC1 trailing arm?
The minimum price for a 1995 Saturn SC1 trailing arm is $50.
Po404 and p1404 codes were pulled on your 1998 Saturn SC1 what are these codes?
What does code 1404 mean on 97 saturn sc1
Does a 1995 Saturn SC1 have a factory alarm?
my 1995 Saturn sl2 has a factory alarm, my daughters 1997 sc1 also has one
What is the radio code for a 1999 Saturn SC1?
1999 saturn sc1 , need radio code. 4 digit from radio is 1407
2000 Saturn SC1 1980000 kms - Car won't start or pass fuel?
The fuel pump is probably bad.
Where is the camsensor on a 2000 Saturn sc1?
Saturn S-series does not have a Cam Angle Sensor. The error code comes from the ignition module. It detects the difference between the spark under compression and a spark under exhaust stroke. The most common cause is corrosion of the spark plug wire terminals or attachment to the base plate for grounding. My car had a defective ignition module that caused the code.
How do you change 2001 Saturn 2001 sc1 ignition?
To change the ignition on a 2001 Saturn SC1, start by disconnecting the negative battery cable to ensure safety. Remove the steering column covers by unscrewing the screws, then disconnect any wiring harnesses as needed. Next, remove the ignition lock cylinder by turning it to the "Run" position and inserting a small tool into the access hole to release the cylinder. Replace it with the new ignition lock cylinder, reassemble the steering column, and reconnect the battery.
