In your fuse panel on the drivers end of the dash ( cover is visible with drivers door open ) the # 7 fuse is a 7.5 amp mini-fuse for the left stop / turn trailer tow connector ( and the # 3 fuse is for the right stop / turn trailer tow connector )
The bulbs should be checked on a 1993 Dodge Dakota if the taillights are not working. The plugs on the trailer package should also be checked to make sure that they are working.
I get about 20mpg with my 2002 XLT 6 cylinde 4.0 when I tow a trailer it dropes to about 13mpg
Overdrive should be used when you're pulling a trailer or extra weight in the bed. At a lower RPM there is more torque, therefore more pulling power.
check fuses under dash panel and for short if wired for trailer
5 to 10 percentwhen are lights required to be istalled on a trailer
When testing the coupling of double trailers, the landing gear of the rear trailer should be fully raised and clear of the ground. This ensures that the trailer is properly coupled and that there is no interference with the towing vehicle. Additionally, the landing gear should be checked to confirm that it is securely locked in the up position to prevent any accidental lowering during operation. Proper inspection of the landing gear is crucial for safe towing and maneuverability.
I was told that the official trailer should come out Friday,May 6,2011. They are filming the wedding in April and that's it for filming. They should have the trailer done by then.
5 to 15%
Brake linings should be checked every 3,000 miles.
5 to 10 percentwhen are lights required to be istalled on a trailer
Before entering a trailer dock, you should verify that your light wheels are docked.
should the shut off valves on the middle trailer of a set of triples be open or closed