0
What else can I help you with?
How can you remove and install a 1996 Ford Taurus 3.0 engine with a floor shift and 4 wheel drive transmission?
1996 Taurus never equipped w/ 4 wheel drive
Where is the shift module on a 1997 Ford Taurus?
were is the shift module on a 1997 Ford Taurus
Where is the shift solenoid located 2001 Ford Taurus?
where is the transmission shift solenoid on 2001 ford taurus
What causes a Taurus transmission to shift hard when moving from park to drive or reverse?
check fluid in tranie....and LUCAS tranie lube
4 wheel drive wont shift on 1998 Tahoe.front wheel lights come on in high speed and front wheels connect.in low 4 wheel drive it will not shift inwhat could be the problem?
can not get 4 wheel drive to shift in 1998 Tahoe
What would cause 1997 Taurus to shift one day and not the next Doesn't shift out of first but for seemingly no reason next start up will shift just fine?
Answer:I had the same problem with my Taurus and found out that the vss (vehicle speed sensor) was sending a faulty signal to the transmission. autozone has it for $30.00 and it takes about 15 min. to put in.
Is the 1998 Ford Taurus a stick shift?
no
Why doesnt 1998 Ford Taurus shift into overdrive?
The transmition is bad it happened to me its the overdrive selinoid also valve body problem possible, solenoid is on valvebody.
What does the code p0761 mean in a 1998 Ford Taurus?
Trouble code P0761 means: Shift solenoid C performance problem or stuck in off position
When I put my 1999 subaru impreza into drive it hesitates but will shift into reverse with no problem the fluid level is good could the filter need changing?
A plugged transmission filter can cause your transmission to hesitate when you shift into drive. A collapsed vacuum hose can also cause the problem.
What can cause hard shifts on a 1994 Ford Taurus Sometimes 1-2 shift sometimes 2-3 shift and sometimes it shifts just fine?
change the fluid and filter its cheap and it usually fixs the problem
What is the problem when the gear shift will change from Park to drive only after resetting?
Most likely a bent part in the tranny.
