The cigarette lighter is wired into your electrical syatem. If your lighter doesn't work, go buy a replacement. The removeable lighter often burns out but the lighter-unit seldom goes bad. You can buy a replacement lighter at an auto parts store.
the one that is blown.
Where is the cigarette lighter fuse for a 2007 Chevy colorado
Fuse Box, it says T/G REL and its a 25 amp fuse
To fix the cigarette lighter on a Chevy Cavalier, check the fuse first. Next check the wiring and the cigarette lighter itself for a problem.
Remove the retaining ring at the top of your 1998 Chevy cigarette lighter. Slide the cigarette lighter out and remove the wiring harness. Reverse the process to install the new cigarette lighter.
To remove the cigarette lighter from a 2013 Chevy Suburban, first, ensure the vehicle is turned off and the key is removed from the ignition. Use a flathead screwdriver to carefully pry off the surrounding trim or bezel around the lighter. Once exposed, gently pull the lighter socket out of its housing, disconnecting any wiring harness attached to it. Replace it with a new lighter or reinstall the original by reversing the steps.
The 2002 Chevy Impala cigarette lighter is held in place with a retaining ring. Remove the retaining ring and slide the cigarette lighter out. Remove the wiring harness from the back of the cigarette lighter. Reverse the process to install the new cigarette lighter
If a Chevy Cavalier cigarette lighter doesn't work, check the fuse. The fuse may be blown and will need replaced.
The 1999 Chevy Malibu cigarette lighter fuse can be found in the fuse box. The fuse box is located in the engine compartment. The cigarette lighter fuse will be in the second column, fourth from the top.
The 1997 Chevrolet Malibu cigarette lighter fuse is located in the fuse box. The cigarette lighter fuse will be in the second column, fourth from the bottom.
I'm trying to get an answer!
Remove the retaining ring on the top of the cigarette lighter assembly. Pull the cigarette lighter assembly out and remove the wiring harness from the back of the assembly. Reverse the process to install the new cigarette lighter assembly.