0
What else can I help you with?
Why is your S10 Chevrolet truck smell like gas when you turn the engine off but is not leaking gas?
because you just got done using it
What year did Chevrolet stop using timing chains in their trucks?
All GM OHV truck engines continue to use timing chains. The 2.2 truck engine (not ecotec) also uses a chain.
Cold engine noise in a 4.3 gmc truck?
The most common cold engine noise in a Chevrolet 4.3L is lifter clatter. Try using a lighter weight oil and see if the noise changes or goes away.
What year did Chevy stop using disributors with points?
1974 was the last model year for points in a Chevrolet.
What are some of the major features of a 1941 Chevrolet?
The 1941 Chevrolet will have different features depending on what car or truck you are looking at. The cars Chevrolet was producing at time were using integrated fenders, a sleeker rounded styling and smoother shifting. The trucks were being designed to combine sleeker passenger sedans with the heavy duty panel truck.
Where is egr valve located 0n 4.3 Chevrolet engine?
If the 4.3 Chevrolet engine is new enough to have an EGR valve it would be located in the exhaust pipe where it meets the engine. Some vehicles did not start using this device until after 2000.
How do you identify the engine of an Chevrolet?
If you are talking about the small block V-8 Chevy engine, there is a small flat pad with an engine id number located on the block, in front and below the passengers side cylinder head. Using that number, visit web Chevrolet engine identification sites to determine which engine you have.
Where is the maf sensor located on a 1995 Chevrolet Blazer with a vortec engine?
Apparently, there is none. They started using them in 1996.
Where can I get online shop that sells LMC truck Chevy parts?
A good place to find IMC Chevy truck parts is at LMC truck. You can find their website at www.lmctruck.com/Chevrolet You can shop online, but have the option of using their 800 customer service line as well.
Can I build a helicopter using a truck's engine?
Can you build the transmission and rotor hub, that's the real point
If I keep using the clutch start cancel button on my Toyota Tacoma will I damage the truck?
Using the clutch start cancel button on a Toyota Tacoma will damage the truck. Damage can occur to the starter and eventually the engine.
How do i set the dwell on a 327 1968?
To set the dwell on a 1968 Chevrolet 327 engine, you'll need a dwell meter. First, connect the dwell meter leads to the ignition coil's negative terminal and ground. Start the engine and let it warm up, then check the dwell reading. Adjust the points gap using a feeler gauge to achieve the desired dwell angle, typically around 30-32 degrees for the 327, by loosening the points screw and repositioning the points as needed.
