To install a convertible top on a 1972 Cutlass, first ensure the frame is properly cleaned and free of rust. Position the new top over the frame, aligning it with the existing mounting points. Secure the top to the frame with the appropriate fasteners, ensuring it fits snugly and evenly. Finally, check the operation of the top and make any necessary adjustments to ensure smooth opening and closing.
10/22-inch Dayton Rams with trues and Vogue tires on a 1994 Cutlass supreme
Does the surrounding fabric require replacement? If your just replacing the glass you may be able to un-zip it and swap it.
Behind the back seat. A person has to take the bottom seat part out and the back prtcome off. it is moued to the body of the car. Very simple to replace
all of the components for the top, including a plug in the side of the motor to fill with fluid from are under the back seat area. Refill for fluid is dex trans fluid.
Any convertible with a back seat.
Behind the back seat
if a 4 cyc, it probably has a (silver) cap on the top of the engine where the return hose goes back to the radiator. thermostat is under the cap.
Remove the wiring harness from the back of your 1995 Oldsmobile Cutlass blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.
To adjust the top of a 1966 Cutlass convertible so that it aligns correctly with the rear windows, first, check the rear bow's positioning. Loosen the screws or bolts that hold the rear bow in place, then gently slide it forward until it meets the windows properly. Tighten the fasteners securely once the desired position is achieved. Additionally, ensure that the top's weatherstripping and any related components are not obstructing the movement.
589
There are 3 seatbelts in the back seat of a Chrysler Sebring Convertible. The middle seat belt is just a lap belt though.
Ebay - Buy a used radio. ~$100. Self-install and move on.