0
What else can I help you with?
How do you remove the harmonic balancer on a 1996 dodge neon?
loosen the center bolt and get your self a harmonic balancer puller just make sure you loosen the center bolt enough but not too much but you need a balancer puller.
How do you change harmonic balancer on 1991 buick lesabre?
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
What size bolt is the harmonic balancer bolt for a 2002 4.7 Dodge Engine?
M14x1.5
How do you remove a crankshaft pulley on a 67 Chevelle?
The crankshaft pulley unbolts from the harmonic balancer. The harmonic balancer can be removed from the crankshaft with a 3 bolt puller.
How do you replace harmonic balancer on 1993 f 350 with 351 motor?
first remove serpintine? fan belt then remove large bolt in middle of harmonic balance. this bolt usually has left hand thread next with a harmonic pulley ,puller, remove harmonic balancer.when removing this, there is a key in the balancer and shaft if a new key did not come with new balancer,make sure not to loose the old one install new balancer with key.use the bolt to pull balancer up tight where it needs to be and use proper torque on bolt
Technician A says the harmonic balancer may be attached to the crankshaft using a Woodruff key and center bolt. Technician B says the harmonic balancer may be attached to the crankshaft using a square?
The harmonic balancer is attached to the crankshaft using a Woodruff key or a square key and center bolt.
How do you remove the harmonic balancer in a Nissan Maxima?
To remove the harmonic balancer from a Nissan Maxima, first you need to removed the center bolt. After that, you can use a puller to remove the harmonic balancer. Before you do this, make sure you disconnect the battery and remove the drive belts.
How do you remove the bolt on the harmonic balancer of a 1998 Lincoln Town Car?
you unscrew it
Chevrolet 350 harmonic balancer bolt torque?
60 ft-lbs
What is the torque Specification for the harmonic balancer bolt on a 94 Toyota truck?
120
What size bolt holds on a harmonic balancer for a 1997 dodge avenger?
22mm
What harmonic balancer do you use on a early 283?
The really early 283 didn't have a balancer. It just had a flange to bolt the pulley to.
