Subjects>Auto>American Cars

Is there a adjustment on a serpentine belt on a 1991 Dodge stealth?

Anonymous

∙ 19y ago

Updated: 10/22/2022

** THIS IS FOR TIMING BELT ** There is nothing for us as users to adjust. Tension is done by the auto tensioner. The timing belt spins the cams, and water pump on these cars. Maitanance scheduals of 60k and 120k are required. Change out water pump, belt, and tensioner. / / / / / / / / I'm wrong!! Oops! The serpentine belt that runs the alternator, AC, Power steer. To adjust the tension on this belt. There is an adjustment hex head screw. Located on the idler pulley. Turn clockwise to raise idler, tightens belt tension. SEE LINKED PAGE: http://www.stealth316.com/2-alt-drivebelt.htm Sorry for the initial mix-up. Da Moo

Wiki User

∙ 19y ago

What else can I help you with?

1991 dodge stealth fuel pump problems?

WHERE DO YOU CHECK THE FUEL PRESSURE ON A 1991 DODGE STEALTH

What is the bolt pattern on a 1991 dodge stealth?

5x114.3mm

How do you change the serpentine belt on a 1991 dodge stealth?

To change the serpentine belt on a 1991 Dodge Stealth, first, ensure the engine is off and cool. Locate the belt tensioner and use a wrench to relieve tension on the belt, allowing you to remove it from the pulleys. Note the belt routing or refer to a diagram for proper installation, then place the new belt onto the pulleys and release the tensioner to secure it. Finally, double-check the belt alignment before starting the engine.

Whats is the registered speed for a 1991 dodge stealth?

160 mph

Where can you get a real factory service manual for a 1991 Dodge Stealth RT TT?

Just go to 3sx.com the have pretty much anything you need for a dodge stealth or 3000gt

Do you have to use premium gas in a 1991 Dodge Stealth RT?

yes, it is recommended

What is the fuel recommendation for 1991 dodge stealth?

91 octane/premium fuel

Does an ecu for a 1991 dodge stealth need mapped after installation?

No, that is for OBD2 cars.

Where is the fuel cutoff relay on a 1991 dodge stealth?

The 1991 Dodge Stealth fuel pump cutoff relay switch is located on the firewall in the engine compartment. You will find the relay switch on the drivers side of the engine compartment.

Srs 1991 dodge stealth?

Take it to the Dodge Dealership and let them either change the sensor or reset the system for you.

Where is the oxygen sensor location on 1991 Dodge Stealth?

they are located right at the exhaust manifold

Where is the ecu on a 1991 dodge stealth?

behind the radio across the back of the center console

Trending Questions

Where is the brake booster located in a 1988 Lincoln mark vii? What type of oil does the 2006 Cadillac SRX use? Name something you might accidentally drop under the seat of your car? What is a 412 cubic inch in liters? What causes Drive line vibration in 2005 dodge ram 2500 4wd diesel? How can you check the fuel pump pressure and how many pounds should it have on a 1998 Chevy Cavalier? How do you replace a Ford Contour egr valve? Where can you find the VIN number on 1992 Chevy pick up truck? How do you replace rear brakes on a 1994 dodge shadow? How much does a 98 Chevy venture engine cost? Any idea how to fix the driver side window that is stuck in down position? How do you reset the security light on a 2001 Alero it won't start while light is on? What can cause coming out through exhaust? Where is the blower motor on a 2000 Dodge Durango? Is 1992 Jeep Cherokee towable on 4 wheels? What was the price of a car in 1964? Do toenails sink or float? How much does a dodge caliber cost? Fuel filter location 94 Buick Regal? Where can you find free diagrams on line for your 1990 Pontiac 6000 specifically the rear suspension?