Have you tried reprogramming the remote? there are instructions in your cars manual on to perform this operation. I'd try that first.
Put double A batteries in it
The batteries may be dead on the remote.
Different batteries in all the different remotes. Just open the remote up and see what kind of battery it has.
yes...it does need batteries but it comes with batteries in it. The battery is at the bottom. To take it out you have to get a pin and put it in the little dint at the bottom. Push it in and the battery will pop out.
I need three batteries for remote starters where do I purchase them? Can I have them shipped
It is the same if you have can recharge your battery or you buy disposable, the Bluetooth remote may require a AA battery or a Lithium 3.0V coin battery. It will depend on what type of remote you have.
To change the batteries in a LiftMaster remote, locate the battery compartment on the back of the remote, open it, remove the old batteries, and insert new ones according to the polarity markings. Close the compartment securely.
To change the batteries in a Dish TV remote control, first locate the battery compartment, usually found on the back of the remote. Slide or lift the cover to open it, then remove the old batteries, noting their orientation. Insert the new batteries, ensuring they are positioned correctly according to the + and - markings. Finally, replace the battery cover, and your remote should be ready to use.
Batteries aren't in properly. Battery contact points dirty. New batteries are faulty.
The keypad doesn't take batteries , the remote takes a battery or batteries
Yes. They use watch batteries.
yes, you need a battery pack though.