An easy way to do this is disconnect the battery for about 5 minutes and reconnect the battery. This should reset all warning lights. ----------------------------------- You need to either look in the owners manual or purchase a Haynes Manual to obtain the information you need. Disconnecting the battery is NOT a good idea as it is possible to get a voltage spike which can damage electronics.
To reset the brake pad wear warning light on a Citroën C5, first ensure that the ignition is turned off. Then, press and hold the trip reset button on the instrument panel while turning the ignition to the "On" position without starting the engine. Continue holding the button until the display shows the reset confirmation, then release it. Finally, turn off the ignition again, and the warning light should be reset.
You can view the 2004 Ford Explorer owners manual online at : www . motorcraft service . com ( no spaces ) Click on Owner Guides The guide shows the warning lights and there meanings
Click on the link below Click on Owner Guides The Owner Guide ( which shows pictures and descriptions ) can be viewed online
on info panel when warning shows just press reset on right side of instrument cluster amke sure your coolant tank is full if warning returns the sensor can be gummed up with engine sealent used by gm, replace sensoe or flush reserve tank with hose,drain it a fill with coolant
You can't reset the parking light - It shows you have a fault at that time - Cure the fault and the light will go out - I have a problem with mine - I have an intermittent fault the light only comes on when the parking brake is faulty - most of the time the lights out
I was looking at a picture in the 2000 Lincoln LS Owner Guide and it shows there are two warning lights in the tachometer ( RPM dial ) The one on the left is the seatbelt warning light and the one on the right is the air bag ( Supplemental Restraint System ) warning light , it looks like a " D " in front of a person who is sitting
You can press the Delete or F2 key to get into bios and then you can reset the settings or you can reset CMOS. This guide shows you how to reset CMOS - http://www.eteknix.com/how-s/how-reset-cmos-122/
its when you reset a stage after the shows over
Its probably a stop lamp switch, most common part for a esp/bas/abs lights. but can also be bas travel sensor, ect.
You can go to monstertrucks.com to find out where the exhibitions and shows are.
www.honda_tech.com
You can view the 2001 Ford Windstar owners manual online at : www . motorcraft service . com ( no spaces ) Click on Owner Guides The manual shows pictures of the warning lights and explains what they mean ( I think you mean the LOW tire pressure warning light )