EGR Valve
4.2L, 4.6L, 5.4L and 6.8L Engines
1. Disconnect the negative battery cable.
2. Remove the vacuum hose from the EGR valve.
3. On the 4.6L engine, remove the nut and brake booster bracket.
4. On the 5.4L engine, remove the DPFE sensor retaining nuts and place the sensor to the side to allow access to the EGR tube.
5. Disconnect the EGR valve-to-exhaust manifold tube from the EGR valve.
6. Remove the EGR valve mounting bolts, then separate the valve from the intake manifold.
7. Remove and discard the old EGR valve gasket, and clean the gasket mating surfaces on the valve and the intake manifold.
To Install:
8. Install the EGR valve, along with a new gasket, on the manifold, then install and tighten the mounting bolts.
9. Connect the EGR valve-to-exhaust manifold tube to the valve, then tighten the tube nut to 25-35 lbs. (34-47 Nm).
10. Connect the vacuum hose to the EGR valve.
11. On the 5.7L engine, install the DPFE sensor.
12. On the 4.6L engine install the brake booster bracket and the retaining nut.
13. Connect the negative battery cable.
If you want to locate a new egr valve, check with your local auto parts store. If you want to know where the egr valve is located on your vehicle, post the year and engine size of your S10.
Its in the back attached to the Throttle body on the drivers side next to the firwall.
The cost of replacing an EGR valve varies with the make, model and location of the car. An EGR valve for a 1996 Lincoln Town Car is about $160.
buy the haynes manual
On my Toyota engine it's to the right of the intake manifold.
it is in with the EGR valve system
go to lincolnsonline.com the answer is there
must buy the EGR valve, EGR position sensor, both are located on the driver side behind the cylinder head (paint in the a#@ to do it)The EGR valve is conected to the intake manifold with a thick metal hose going to the exaust . The EGR position sensor it has a rectangular shape this one has two rubber hoses one thin other thick both conected to the EGR's vave thick metal hose.
Check the EGR valve.
It is on the back of the engine under the wiper area
The EGR valve is located at the front of the h22a4 engine. The EGR valve is right beside of the front of the EGR valve.
Locate the intake plenum on the back side of the engine. The EGR valve is on the right side of the intake plenum or manifold. It has 2 bolts holding it on. It has a long tube going down to the exhaust pipe.