0
What else can I help you with?
Where is the knock sensor on a 4x4 1991 Ford Explorer?
There is no "knock sensor" on a 4.0L engine
What is the function of a knock sensor on a 1991 4.3 s10?
The function of the knock sensor ob a sensor on a 1991 4.3 s10 is to provide the computer the position of the crank shaft to give it the right information to get correct timing. That would be the crank position sensor. The knock sensor monitors the engine for spark knock (ping) so the ECM (Engine Control Module) can retard the timing to eliminate it.
Where is location of knock sensor 1991 Toyota truck with 3.0 3VZ-E?
The knock sensor is located in the block, under the intake manifold. You have to basically remove the top end of the engine to get to it. The pigtail which connects the sensor to the harness is usually the culprit. It is notorious for failing but after spending all the time and money for gaskets I would recommend replacing the sensor as well.
Where is the knock sensor on a 1994 Jeep Cherokee Sport 4.0?
There is no knock sensor on a 94 4L jeep engine. In 1991 when they changed to the 4L HO motor, they removed the knock sensor from the system.
Location of the MAP sensor on a 1991 Chevy Blazer?
where the map sensor on 98 blazer?
Where is the knock sensor in a 1991 Chevy Silverado?
It is screewed into the passenger side of the engine, just in front of the starter.
Airbag sensor location in 1991 geo storm?
airbag sensor and iat sensor are not the same thing... wiki
Where is the knock sensor on a 1991 Olds Cutless Supreme?
The knock sensor is located on the left side of the block. Often the steering shaft will contact and wrap the wiring harness around it, braking the connector. You should check this first, before replacing the sensor.
Where is the knock sensor on a 1991 300zx 2 2 non turbo?
The knock sensor on Nissan 300ZX non-turbo from 1990 thru 1996 is located below the lower intake manifold on the rear of the engine block. To replace the knock sensor the upper and lower intake manifolds need to be removed. It is always best to replace the knock sensor with a new one considering its major dissasembly.
Location of knock sensor Toyota 4Runner 1991?
Directly under the lower intake manifold. the connection for this sensor is below the throttle body. If replacing sensor the sub harness should be replaced as well. Assuming it is a V-6 it is directly under the lower intake manifold. connection can be found under throttle body.
How many sensor is on a 1991 Toyota Cressida?
There's many sensor, O2 sensors, (Palet type ) Airflow sensor, Throttle body position sensor. Knock sensor and probably much more for brake, speedo and transmission.
What does a knock sensor for a 1991 Chevrolet Camaro 305 look like?
the knock sensor on a 91 camaro 305 in on the passenger side of the block, bellow the exhaust manifold. its a few inches in front of the bell housing., and has a single wire running to it. looks a bit like a temp sensor, or oil pressure sensor.
